The glass has a safety switch so it will not raise when the door is let down. Bypass the switch located right side, close to the locking latch (not the one on the door). you may also have a bad switch on the door. i had both
If your driver's side window goes down halfway and gets stuck in a 1999 Chevy Suburban, the motor could be failing. It could also indicate the window is off the track.
My 99 gmc suburban is stuck in 4 wheel drice low
If the armrest on a 1992 Suburban is in the locked position and will not unlock, check for a foreign object that might be stuck in the hinge. Sometimes the armrest can lock if the bolt holding it on is too tight.
The thermostat may be stuck open
You should have a mechanic check your window to see if it is off track. If it is not, then they will be able to replace the computer so that your window works.
break the window
window reflection ask someone feel with tongue look in spoon use cell phone
Mayella Ewell gets stuck in the window during the fire at the Ewell house in "To Kill a Mockingbird."
There are two possible conditions this question is describing. The first is that the window is seized and inoperable at the middle down position. The second is the window will go no further than middle. In the first it is a sign of a failed motor or regulator. In the second it is possibly an obstruction of the motor arms or window guides. Disassembly of the door panel to access and diagnose will be required.
First take the door panel off and inspect the wires, the window track, and motor. My tempo has a stuck window as well. My window track is really rusty, and I think could be the issue.
remove inner door panel. check window mechanism. it may need oiling. if not u should be able to force it up by winding window up & putting pressure on bottom of window at same time.try spraying with WD 40 first
Before trying any repair on the window, check the fuse and make sure it is not blown. If it is, replace it. Make sure the wires leading to the fuse box and all tightly in place. If this doesn't fix the problem, check the window control switch. If it is dirty, clean it and see if the window works. If not, remove the switch and set aside. Remove the access panels on the door. Use an automotive test light to check all of the electrical wiring in the door. Tape the window in place to prevent it slipping. Replace the window motor and the window regulator. Remove tape and make sure window works.