Don't see your answer below? Submit your question and get an answer from the WikiAnswers® community.

How do you route a serpentine belt for a 1997 Jeep Wrangler?

there should be a routing diagram on the hood of your jeep or right above the radiator on the radiator support. if not on those 2 places check the airbox cover... it might be (MORE)

How tight should the serpentine belt be on a 1998 jeep wrangler?

Answer   There is no adjustment to the tightness. The idler wheel holds the proper tension.     CORRECTION:   There is adjustment and it's found on the Power S (MORE)

How do you take off a serpentine belt for a 1994 Jeep Wrangler automatic?

  Answer     If it is a 4.0, loosen the two rear steering pump mounting bolts, the upper pivot bolt, and the locknut and the adjusting bolt located on the bottom (MORE)

How do you route a serpentine belt on a Jeep Laredo?

  I highly recommend spending a couple dollars on a Haynes manual. I bought one, and I had this same issue. Gives the best diagram I can find   ------------------------ (MORE)

What is the serpentine belt routing for 1998 Jeep Wrangler 6-cyl with AC and power steering if the routing sticker under the hood is missing?

    Pinch the belt into a loop, pass "the loop" down the right side of the fan & slip it onto the crank pulley,pass the "non-ribbed" side over the water pump, then lef (MORE)

Jeep Wrangler serpentine belt replacement?

There is a tensioner under the power steering pump. Lossen the pulley with a 15MM socket .. Do not remove it ... On top of the bracket to the left of the PS pump there is an a (MORE)