0
Locate a small, black button protected by a black cup on the bottom edge of the dashboard, just up and left of the brake pedal. It is not on the floor or under the dash, but right at the edge, in front of the on-board diagnostic computer connection. Put your keys in the ignition, and when you locate the button, press and hold it. turn on the ignition (not start the car) while holding the button for around 20 seconds and . You will hear the locks lock and unlock three times. This should fix your problem.
If you have difficulty locating the button, you're probably looking to hard for it--mine was hanging from a wire at the very edge, not even protected by a black cup.
Good luck =]
Wiki User
β 14y ago
Add your answer:
Earn +20 pts
Is there a reset button on 2003 Subaru Outback?
where is black reset button umder drivers dash
Where is computer reset button located on a 98 subaru impreza outback?
There is no reset button. Disconnect the battery for a few hours, then reconnect and the computer's memory will be erased. You'll have to reprogram your radio setting.
Where is the ECM reset button on a 1999 Subaru Outback Impreza?
There is no reset button. The computer is reset by repairing whatever tripped the CE light, and then using a scan tool to reset the light. Reset the light without repairing the problem and the light will just come back on.
How do you reset 1999 Subaru Outback alarm?
find the reset button under the drivers dash, its atached to two brown wires. once you've found the button turn the key on and hold the button at the same time. this will reset the system and stop the lights from flashing.
How do you reset vdc off light in subaru 2001 outback?
Try holding the "VDC off" button down for 10 seconds. Not sure, but worth a try. I think I might reset when you start up again.
How do you reset the oil change light Subaru Outback you?
A person can reset the oil change light on the Subaru Outback by turning off the vehicle and disconnecting the battery. Also, it is important to check the oil level just in case there is an issue.
Reset Subaru legacy?
remove negative battery cable for 15 minutes
How do you reset the computer for the 98 Subaru Outback Legacy?
Remove one battery terminal and touch it to the other to discharge capacitors in the system. Reconnect the terminal and you are good to go. Don't forget to clean the terminal while you have it off.
How do you Reset Auto Door Locks on a 1998 Subaru Outback?
How do you reset the auto locks on a 1998 Subaru. Disconnected the battery to clean terminals. Now the auto lock does not work from the door switches
Why are my parking lights flashing after a battery change in a Subaru Outback 1996?
There is a small black button hanging down just above gas peddel under your dash to reset this problem. You have to hold it in till you hear all the door locks reset ,then your lights will stop flashing.
How do you reset check engine light in 1998 Subaru legacy outback 2.5?
You need an OBDII computer a) to read the reason for the check engine light, and b) to reset the error code if you know what caused the light to come on. If you don't fix the condition that caused the light in the first place, it will probably occur again.
Is there a computer reset button on 2000 Subaru Outback?
No, there is not. Most code readers will allow you to reset the check engine light, but you can reset it simply by disconnecting one battery terminal and touching it to the other to discharge capacitors in the system. If this makes you nervous, just pull a battery terminal and leave it disconnected for 45 minutes or so. When you reconnect it, the computer will be reset.
