answersLogoWhite

0


Best Answer

Could be your fuel pump. Vortec engines are very touchy

with fuel pressure

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1998 Chevy C3500 350 Misfire new spider injection plugs cap rotor coil IT'S like one injector not firing is it possible ecm no check eng light no codes?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What does misfire mean?

Misfiring means it is not firing on all cylinders. Bad plugs, plug wires, burnt valve, blown head gasket, defective injector are possible causes. Or a combination of more than one of these.


Fuel injection firing order for Datsun 280zx?

There is no firing order with datsun injection. It is a "batch fire" system. That means when 1 injector fires they all do. The system gets a signal from the ignition coil as to when to fire.


Why does a Honda Accord shake when running?

It possibly has an engine misfire, one of the spark plugs is not firing, or not firing correctly. It could also have a partially clogged fuel injector. If the car has had a timing belt service done recently, it may be possible that one of the counterbalance shafts is out of time.


What is the sensor on an escort diesel injector?

Hi, it is part of the injection timing system, it sends a signal to the ecu to help it work out the firing point of the injection pump. Another sensor works off a trigger on the flywheel.


What is the firing order for injector?

Injector firing is determined by the ECU (engine computer). Many early electronic injection systems used a gang fire technique, where all injectors were fired at the same time, once for each complete ignition firing sequence, and some were bank fire, (V type engines) firing each bank once per ignition cycle. Most modern engines are now sequential fired, where each injector is fired individually, at a specific time interval prior to that cylinders ignition event.


How do you change ford 5.0L to 5.0L hi output?

The difference between the 5.0 and 5.0 HO is primarily in the firing order. The HO shares the same firing order as the 351W. You would need the cam for sure. If you are running a carb and pre computer ignition you'd just need to change the routing of the plug wires. Fuel injection would require the correct programming in the computer. I suppose it would be possible to fool the computer by re-routing the injector wiring to the appropriate injector for the HO firing order.


What does it mean when you change plugs and wires run two bottles lucas fuel injector cleaner through system and still have multiple misfire and power loss on 1999 Monte Carlo?

Probably have a bad ignition coil Which cylinder is not firing?


On a 1990 Nissan maxima what is the problem when the fuel injector stop spraying?

the harness could be bad on that injector chech to see if its firing and if it is then the injector is bad


If your temperature gauge on your 1998 Lincoln navigator is bad will it make your engine misfire?

No the gage has no effect on firing. An engine that is overheating will misfire.


Susuki vitara P0304 code misfire 4 cylinder replaced plugs still misfires?

this could be caused by a fuel problem, not spark. check to see if your getting spark to the plug. ck to see if the injector is firing, and run a compression test on that cylinder


How can a gun have a misfire?

It depends on what you mean. If you mean an actual misfire, that is caused when the primer does not ignite. That is normally caused by a firing pin problem, or by a bad primer.


What are the symptoms of a distribor cap going bad?

misfire on adjacent cylinders in the firing order.