On a 3.1L V6, it is located on the passenger side of the engine, towards the front. There is a smooth, shiny metal pulley over the top of it. To remove/replace it, you will need to loosen the tension on the belt by raising the belt tensioner pulley, located on the bottom directly below the alternator. Once loose, slip the belt up over the alternator pulley, and lower the tensioner. Remove the 4 bolts holding the pulley onto the water pump. To prevent the pulley from turning, slip a large flathead screwdriver (or tire iron) into the hole in the motor mount directly above the water pump pulley. This will bind against the bolts as you make your way around. Be sure to loosen all bolts first before completely removing them. Once they're all loose, you can remove them by hand, and slip the pulley off the water pump. There are 5 small bolts holding the water pump to the engine. They are spaced around the outside ccircumference of the water pump. Once all 5 are removed, the water pump should come out. If not, tap on it lightly with a rubber mallet. Sometimes the gasket sealent likes to stick. Once removed, be sure to scrape all traces of the old gasket material, and clean the surface with acetone. Installation is the reverse or removal. Check for lost coolant, and add more if needed to the proper level. Start the engine and allow it to reach opearting temperature. Check for leaks. None? You're done!
I have a 93 Chevy Beretta and mine is located INSIDE my fuel tank so I would look there. in the fuel tank
The 93 Beretta does not have a distributor, it has coil packs.
no
can u sell me your car call this number 000
Autozone.com has a fuseblock diagram. Our '93 Beretta is not here for me to go put the fuse block cover on the scanner (fuel delivery problem....), but go look that up. Fuses is called "circuit protection" after you get through all the narrowing it down to 1993 Chevy Beretta Chassis Electrical....
The water pump on a 93 cavi is $32.99 and comes with some kind of fan assembly. keep in mind the cost of anti-freeze.
12 volts
Go to autozone.com and you will find detail information on how to change the water pump on a 93 caviler.
ALL Chevy Berettas built after 1991 came with factory driver side airbags in the steering wheel. If your 93 doesn't have one, it was removed by a previous owner.
Get a fuse panel cover at a junk yard
Has the rad ever been flushed? Try that if there is no indication of water pump failure (leaking or venting coolant from pump.)
video how to take off step by step water pump and timing chain Saab 93 2004