Following are the advantages of Live Tank over dead Tank :
a) The Primary conductor is short than (in live tank CT) than the Dead tank CT which gives better Rigidity and gives high short circuit current withstanding capability and reliability.
b) Primary winding is uniformly distributed around Core, Hence CT is truly low reactance type, which has inherent better transient performance.
c) Due to shorter length and the tank being live the major insulation is not over the high current carrying primary, which is the main source of heat (as in the case of Dead tank type design.) the insulation does not get heated up while dissipating the heat generated. This facilitates much superior thermal stability of insulation and longer life.
It's not exact but it's around $98-$150
Possible causes: * dead battery * no fuel in the gas tank * blocked fuel filter * non functioning fuel pump * defective spark plugs * engine timing (needs tune-up)
The tank is not venting properly.
There are usually 2 or 3 straps around the tank. You can remove the adjusting bolts and the straps will open. Make sure you have a floor jack or something else to support the tank when you remove the straps. Once the straps are off and the fill tube has been disconnected, lower the tank just a little so that you can get to the electrical and fuel line connections.
Check the starter! It happened to my 2000 dodge durango too.
Construction wise, in a live tank PT, both the primary & secondary windings will be placed on top tank. In a dead tank PT, primary & secondary windings will be placed in bottom tank.
if you can live with the smell
They will turn brown if dead.
a scorpian is a highly powerful human vehicle that has an advantage over covenant vehicles.
BLODDY HELL, ITS A DEAD CLAM, GET OVER IT! By Waterloo Gang
Surprise air and tank blitzkriegInvasion of Poland was done by Germany who had a numerical advantage and experienced troops.
Electrical equipments (circuit breakers, current transformers etc.) can be categorized, based on their construction, in to two broad types 1. Live tank type 2. Dead tank type As the name suggests, a Live tank equipment's operating system (interruptor chamber in case of CB and tank in case of CT/PT) are live parts during operating and are placed at a height governed by the statutory norms of the country of use. Whereas in case of Dead tank equipments, the operating system is placed in a chamber which is ground during service and hence no statutory norms regarding height of chamber are applicable.
The enclosure that houses winding in other words the tank is at line potential while in the other case it is at earth potential. it is the same in case of circuit breakers too. From NK Sharath Kumar cell 93412 55090 res fax 080 22290151,l/l 080 22233669,sharathkumar@vsnl.net With live tank circuit breakers, the enclosure that houses the contacts is energized, ie. "live". Dead tank circuit breaker's contact enclosures are not energized and are connected to the ground grid. Live tank breakers are usually less expensive but you have to have separate current transformers.
no - never buy a fish from a tank with a dead one in
It will be stress to your fish and even it can be dead. So do not, I repeat, DO NOT OVER DOSE!
If the mom crayfish is dead, you should remove her from the tank. Leaving her in the tank can cause bacteria to grow, making the babies sick.
They did not run him over. After stepping in front of the tank, jumping on top and talking to the crew, he jumped off and blocked them again. At this point, two people in blue clothes took him into the crowd. Some people say this was the Chinese secret police and that he was executed. Others say he is still alive. No one knows for sure as there is no body, live or dead.