0
Should be if undamaged.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Do you have to realign a 2001 Chevy venture after you replace the front wheel bearings?
No.
Where are the horns on Chevy Venture?
the are supposed to be behind the front bumper
Acuator valve replacement for heater 2005 Chevy venture?
my heater fan in front of my 2004 chevy venture van wont work
Where is the airbag module on a 2002 Chevy Venture?
The air bag module on 2002 Chevy venture is located between the driver side front seat and the passenger side front seat under the carpet
What is the tire pressure for 2000 Chevy Venture?
The correct tire pressure for a 2000 Chevy Venture is 32 psi front and rear. This is for the original tire sizes of P215/70R15 front, and P225/60R16 rear.
What are torque specs for Chevy Venture front brakes?
bolt torques for front callipers slide and mounting
How do replace front wheel bearings on a Chevy Venture?
The procedure for replacing the bearings on a Chevy Venture is quite straightforward. Remove the inner drive seal protector first, then secure the rotor by placing a punch into the rotor vents and the brake caliper, and remove the hub nut and washer. After removing the brake caliper, a removal tool will be required to pull the hub free. Ample grease must be used on the hub, seals and the new bearings, and use 38 foot-pounds of torque to tighten the brake caliper, and 185 foot-pounds on the hub nut.
Howling front end on 96 Chevy pickup?
Need to check left and right front wheel bearings.
How do you replace the front wheel bearings on a 2001 Chevy S-10 ZR2?
Did you ever get anywhere on this thread? I'm looking to replace the front bearings and rotors on my 2000 ZR2.
What could cause the front tire to click as you turn on the 2006 Chevy Malibu?
bearings
Where is the harmonic balancer on a 1998 Chevy Venture?
It is on the front of the motor, it will be the bottom most pully.
How do you change the wheel bearings on a 2005 Chevy 4 wheel drive pickup?
If you are referring to the front bearings, you have to buy a complete hub assembly.
