in the old days bleeding a fuel injector system was necessary. Today really not an issue. Some mechanics say it still necessary especially if you run the tank and fuel rail completely dry. Usually turn on the key and the fuel pump imediately pressurizes the fuel rail. You can "CAREFULLY" check this by doing the above.THEN DISCONNECT the battery and disconnect the fuel pressure rail end and see if fuel trickles out. HAVE A WAY TO CATCH FUEL!! and no sparks !!!!!!!!! You will find if fuel is there then it is something else like fuel injectors?fuel injector signal from ecm. If no fuel check fuel pump /fuel pump relay/ fuel filter/and purchase a good fuel pressure guage from SEARS with adapters to see what the fuel pressure is.Also we need to know what the engine is,2.4,3.0.etc.
No, it will bleed itself when it runs.
In order to bleed a fuel system on a diesel x-trail you will need to release the fuel in the system. This can be done by removing the fuel system or draining the pump.
If This Is To Remove Air From Fuel Lines. Forget It. You Do Not Have To Bleed The Fuel Line.
you should unhook supply line and return fuel line from back of head this will bleed fuel from head. to bleed entire fuel system unhook fuel lines at fuel tank be sure to plug fuel tank or you'll loose all your fuel in tanks.
ftygin
I'm not sure why you would want to do this. The fuel pressure reguator will automaticly bleed air from the system.
you dont have to it does it itself
No need to bleed lines, since the system is under pressure.
It's Located inside the Gas Tank.
Shoot it. I find shooting people makes them bleed... same basic idea.
There is a schrader valve on the fuel rail that will allow you to blled the system. This is not normally necessary as the air will be pushed out by the fuel pressure.
take to a garage to bleed needs a mehanical tool to prime bleed the fuel, if u try to self bleed it by turning the engine over u will destroy the fuel pump, and big money to replace it