0
the bolts in the upper control arm have cams on them to adjust the camber and caster.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you calibrate digital gas gauge on 01 mercury grand marquise?
There is no adjustment or "calibration" for this.
How does twenty inch rims affect 2001 silverado?
want to put twenty inch rims on my 01 silverado would like to know how this affect the truck ride
Where is the bank 2 sensor 1 on a 01 Chevy silverado 1500?
Bank 2 is the side of the engine where the #2 spark plug is. On my 99 Silverado it's on the passenger side.
Are the bolt patterns same on 97 vs 01 Chevy Silverado short bed?
Hhh not easy
How do you replace heater resistor in 01 Chevrolet Silverado?
You will need to remove the dash and it should be somewhere under
How do you set timing on a 01 deawoo leganza with 2.2 dohc?
Timing is controlled by the computer, adjustment is not possible.
How many quarts do a 01 1500 v8 5.3l Chevy silverado take?
6 qts. with new filter.
Where is knock sensor on 01 silverado?
Need to know the engine size. YOU will need to ASK your question again. THANK YOU.
Where is the camshaft located on 01 silverado?
3-4 inches down from front and rear center inside motor
Why does my 01 Chevy silverado run out of gas at half tank?
the float in your tank is probably bad, causing inaccurate readings.
What temperature should a 01 Chevy silverado run at?
195 to 210 degrees is just fine. If any hotter then there is a problem.
Does the 01 silverado have a modulator valve?
NO. The transmission in that truck is electronic. They STOPED using a modulator valve back in the late 80s.
