NO.
Not recommended.
It should be 8 inch
yes
yes.
YES, It is bolted in the lower passenger side of the timing cover behind the harmonic balancer It is held in place with 1 10mm bolt
Yes.
60 ft-lbs
Yes.
The torque specification, for the harmonic balancer on your 350 cubic inch engine, is 280 pounds per square inch. The torque specification may vary according to the manufacturer of the engine.
Look at your harmonic balancer the 1 on the 350 is bigger than the 1 on the 327.
the harmonic balancer, is the pulley on the front of the crankshaft. this is used to balance a crankshaft.
the harmonic balancer on the 350 is about 10 inches in diameter compared to a 305 it has about 8 inch diameter on the harmonic balancer