Because Copper is a conductor and conductors do not hold electricity. The charge flows out. But, A copper rod can be charged if it is in a rubber handle. This will result in the charge staying in the rod, thus charging it.
It is static electricity.
A carbon rod may be an insulator or a conductor. It depends on which allotrope of carbon we're talking about. Electricity can travel through a graphite (carbon) rod easily, but it cannot travel through a diamond rod. Both graphite and diamond are carbon, but the former is a conductor while the latter is an insulator.
The plastic rod gains static electricity.
Iron conducts both heat and electricity very well.
Copper rod is covered by insulating materials, because copper is good conductor of electricity when we touch copper rod we get shock and insulators are bad conductor of electricity hence copper rod is covered by insulating materials
Because Copper is a conductor and conductors do not hold electricity. The charge flows out. But, A copper rod can be charged if it is in a rubber handle. This will result in the charge staying in the rod, thus charging it.
Acid itself cannot generate electricity. The electricity is generated by the flow of the electrons. So we can use active metal & inactive medal with acid to generate electricity. For example. If you put a copper rod and a zinc rod in acid solution (for example, HCl), connect the two rods with a conductive wire (metal wire). The the electricity will be generated because the electrons will move from the Zinc (active) rod to the copper (inactive) rod
Electro magnets differs from permanent magnet because it requires electricity. A simple electro magnet consists of an iron rod wrapped in a coil of copper and when electricity flows through the copper, a magnetic field is formed.
conduction is the ability of something to allow something else to pass through it. eg. a metal rod conducts heat water through a pipe electricity through a wire
Copper is good for electricity conduction.The entire rod became hot by conduction.
Any metal that will conduct electricity. Steel works fine, since it is strong. A ground rod driven into the ground and connected to the lightning rod with a wire or cable. The ground rod is usually copper clad (or plated) steel.
it is a rod made of copper
It is static electricity.
wire , copper rod en magnetic wire
because copper cannot conduct static energy but polythene can.
A solid rod because it has more particles in it. The heat then has a solid area to travel through and heat travels best through solids. I think you know the rest.