0
Yes. If you want a good finish that will last, the gelcoat must be well sanded with 240 grit paper, primed with an epoxy undercoat and topcoated in 2-pack urathane gloss.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where can I find Fiberglass roofing panels to enclose my front pourch?
You can find fiberglass roofing panels at H & F Manufacturing Corporation which is located in US
How do you paint fiberglass truck toppers?
Most people choose to paint fiberglass with a sprayer. The paint is sprayed in much the same way that spray paint is.
Do Corvette bodies rust?
The fiberglass panels won't but the frame can.
Motorhome that has vinyl tape with print on it The print bled through to the fiberglass panelsI want to remove all the vinyl tape What can I do to get the bleeded numbers off the fiberglass?
Try a very fine rubbing compound
What kind of paint would work to paint fiberglass fishing rods?
Use oil based enamel paint.
How do you paint door panels?
buy auto interior paint from auto parts store. clean panels 1st with grease removing cleaner,then dry. paint at close to 70 degrees
Who makes fiberglass reinforced plywood panels in northern Indiana?
Crane Composites in Goshen Indiana
Can you use muriatic acid to clean paint stain on a fiberglass boat?
No
What type of stain would you use to refinish a fiberglass door that is peeling?
Fiberglass won't take stain. You need to get all the flaking paint off, scuff the surface and then paint with an enamel type paint. A yacht supply store will set you up.
What are the release dates for MuscleCar - 2001 Project Limelight Engine Accessories and Fiberglass Hood Paint?
MuscleCar - 2001 Project Limelight Engine Accessories and Fiberglass Hood Paint was released on: USA: June 2011
Is there a paint that can be used on a fiberglass boat shower?
Fibreglass is best painted with a two part (twin pack) polyurethane paint.
Is fiberglass bullet proof?
There are a lot of "depends" to answer this question... like what is the ballistic threat? what type of fiberglass? what form? There are bullet resistant fiberglass panels. These are flat rigid panels made with woven roving E-glass. (this is not chopped glass like the hull of a boat). They are compressed with resin and come in different thicknesses based on the bullet and velocity it is required to stop. You can check information on armorcore.com, they are a manufacturer.
