Want this question answered?
To program a GPT universal remote control, hold down the power button at the same time with the button for the device that is going to be programmed. When the other buttons on the remote blink, let up and press on the power button again. The device should turn on. If not, repeat the process.
You can program your GE universal remote, to your converter box, by holding the power button in until the auxiliary read lights aluminate red. Select auxiliary and input the proper code.
You should not have to program this remote.... although it says universal on it. This is an original remote and should work when you put the batteries in. For T.V viewing, just push the t.v button on the top of the remote then power/on-off .... wait for the light, then the sound, then begin with your normal activities.
Try running the universal remote programming codes until one works. There should be a sheet of codes that came with the remote. If that doesn't work than chances are that you may have other problems with the TV.
normally you press the power button on the tv. if that is not possible then grab the remote for that tv and press the power button on the remote control. in the case where neither of the first 2 suggestions did not worked or is impossible then i would say use a universal remote control with the learning feature. these types of remotes can turn on mostly any device with an ir sensor. just point and click. using a universal learning remote should solve this tv problem for you.
Make sure the device is on. Hold down the tv (or whichever device your trying to program) button first and then the power button simultaneously until the red light stays on solid. Then press the power button, it will flash one time, and keep pressing slowly letting it flash until the device turns off. Then press the stop button...and it is programmed.
PROGRAM A TRISONIC UNIVERSAL REOMTE TS-rc 411
To program a Symphonic TV with an RCA RCR-612 universal remote, there are four codes which you can try. Those codes are 1033, 1038, 1046, and 1047. To try the codes, press and hold the TV button on the universal remote. After you enter the fourth digit, the power light will turn on. Once the light is on, release the TV key. If the power light turns off, you have the correct code and can now use the remote. If the light blinks, it isn't the right code and you need to repeat the procedure until you find the right code for your particular TV.
pretty simple just press and hold the device button enter the 4 digit code press power once you have entered the right code the device will shut off.
The Radio Shack 15 _ 302 universal TV remote can be programmed by holding down the power button, until all of the lights flash red. Select the TV button. Input the proper code and the TV should shut off.
Press the power button on the console, or if you have a Wii Remote connected to the console, the power button on the remote. The power button on the console is located to the top-left of the disk slot, and above the D-Pad on the remote.
To program a remote keyless entry on 1996 Chevrolet pickup, first hold down the power unlock button of the door panel. Second, turn ignition key ON, OFF, ON, OFF. Then release power unlock button on the door panel.