Can you put a 1.6 geo engine into a car that had a 1.8?

Can you put a 1995 Geo Tracker engine into a 1997 Geo Tracker?

if they are both 16 -valve engines ,yes if one is 8-valve & the other is 16-valve, then short block only ANSWER: The '95 and '97 Trackers have different sensors and ECU's. The only way you could put a '95 engine in an '97 TRacker would be if you also had the ECU from the '95

What car can you drive when your are 16?

a reliable car is i 92-94 geo storm or geo metro but even a more reliable car would be a lombo this is chance im out

What engine is in a 1995 Geo Tracker?

16 valve 1.6 liter 4 cylinder.

Is the 1996 Geo Tracker 16 L engine an interference or noninterference engine?

Hi, my schematic shows a noise suppressor filter that's connected to the distributor which I believe that's it's an interference engine if I think I'm reading what you're looking for. I just haven't found where in the car it is yet. All I can go by is what used to be and then it was at the distributor or the coil but I'll look and see tomorrow if I can locate where it is. Its acturally a non interfering engine!. Me and father bolth have a 91 and 94 Geo Tracker. Geo/suzuki did not make any severe changes to the model until 99. that's when Chevy bought the company, geo off of suzuki. and that's when they started to get gay! hahaha I have had my timing belt break on me and my car still runs to this day all I had to do is put a new timing belt in it that's it! and getting the timing back is easy there's nouthen you can do to make it any worse then it is. you just line up the dots!

Will a 1989 suzuki engine interchange with a 1995 tracker?

Yes it should, with a bit of work. But first, is the car registered or do you intend to register it? In CA anyway, it is illegal to put an older engine in a newer car, and if you do and get caught you will not be able to register the car. It IS legal to put a newer engine in an older car, but technically then it must pass the smog rules of the newer engine, which means it could be problematic. But if you're looking at a pure off-roader that's something else. The reason I say "it should" is that Geo Tracker 1600cc engines were commonly swapped into Suzuki Samurai's to give them more power. Generally you would put an 8 valve Geo engine into a Samurai...if you had a 16 valve Geo you had more stuff you needed to bring over with it. SO: If your Geo Tracker has an 8 valve engine: The samurai engine should be able to reuse the same intake and exhaust manifolds. The bell housing of the transmission will probably not have "ears" in the right places to bolt onto the samurai block, so it will need modification. And there may be challenges with the starter too. I never made a tracker engine -> samurai body swap but had read a lot about it. Some folks sold an engine/transmission adapter plate, others talked about just having someone who could weld aluminum weld on new ears on the bell housing. Since the Geo is fuel injected, it uses an electronic fuel pump at much higher pressure than the carburatored samurai used. The Samurai "head" will have an eccentric off the camshaft to drive a rod out the side of the rear of the passenger side of the head to drive the mechanical fuel pump. But since you will be reusing the Geo manifold, fuel injector, and fuel pump you do not need the mechanical fuel pump off the samurai engine. So you could just unbolt the samura fuel pump, pull out the little rod or shaft, and then make a small trapizoidal shaped plate to bolt on in place of the fuel pump so oil does not pour out the fuel pump hole. IF you have a 16-valve Geo I would not consider using a Samurai engine....you would have to swap in the Samurai intake manifold and carb, and keep the mechanical fuel pump and disable or eliminate the stock geo one, and on and on. It would be a lot of work to have a much weaker engine.

Will a 89 Geo Tracker flywheel fit a 95 Tracker?

I'm trying to put a 92 5 speed flywheel behind a 16 valve engine and it won't line up. So apparently the cranks and flywheels changed in 94.

Timing marks 1996 geo tracker 1.6l 16 valve?

The 1996 Geo Tracker 1.6 liter engine timing marks can be found on the outside of the main pulley. The timing marks will be scattered around the pulley.

How can you tell if a 1994 Geo Tracker is an eight or 16 valve?

16 valve engine not put in a Tracker till 1996. 1994 Tracker is 8 valve (but a Sidekick may have the 16 valve in 1994) Actually there were 16 valve Trackers before 96. I have an early 95 which is 16v version. I believe 16v engines started somewhere between 91-94. I do know that the valve covers usually state 16 valve when it is. ,the spark plugs in a 16 valve are waaayy down in the top of the engine,you need about a eight inch extention to get at them

I put coolant 16 fl oz in the gas tankmy first reaction was not to drive my car until I empty the tank instead what I did is to fill up my tank 11 gals how does this affect the engine?

Um 1 way to put it DONT

How many spark plugs does a Bugatti have?

Their newest car the Veyron 16.4 has a w16 engine. 16 cylinders, 16 spark plugs

Can a 16-year-old lease a car and put it in his name?

Not in most states--16 year old cannot enter into a contract

Will a Geo tracker 16 valve engine block from a 94 or 96 fit in a 92 Geo tracker Which has an 8 valve engine both are 1dot6 L I think?

It will bolt up. You can not install a 8 valve head on a 16 valve lower end without changing the pistons. The injection is completely different and wireing as well as well the computer. I just completed the swap with ALOT of headaches. believe it or not LOL we used a router with a mill bit to cut down the pistons talk about okie but hey its running perfect now 2000 miles later. my advise is keep the 8 valve head with the car change the pistons and use ALL the brackets off the 8 valve engine.