NO. PVC is for cold water only, CPVC is for hot or cold. I say forget the CPVC and just use pex.
yes it can use
Chlorinated Polyvinyl Chloride (CPVC) pipes can withstand heat up to 180 degrees. A special glue is used to blond it together. PPR pipes are a made of plastic and uses no glue as it is heat-fused. PPR is a commercial product.
I would`nt... It serves no purpose. If the water is off there is no pressure when you turn on the tap, hot or cold, so you would be heating water you can`t use.
Instantanoous multipoint water heaters : These provide hot water to multiple taps or appliances at the same time. when the hot tap is turned on, a powerful gas burner in the heater ignites. The incoming cold water is heated as it flows through a large heat exchanger located above the gas burner. The heat ecchanger heats up a large volume of water very rapidly. They do not supply hot water to a cental heating system. Combination boiler : These provide hot water to the central heating system and instantanious hot water to the tap. when the hot water tap is turned on all the heat is diverted to the heat exchanger to give a rapid responce. hope this is of some use. austin mod 6
Yes.
Always use cpvc for hot water and PVC for cold water.
no, use CPVC instead.
No, certainly not. PVC pipes can only take a certain tempreature and in most cases cannot withstand tempreatures above 60 degrees celcius. if a thermostat fails in a geyser and the hot water over boils and you run water through your PVC pipes, they can melt causing severe damage. the best pipes to use are copper and galvanised depending where you live.
There is no special PVC pipe. CPVC can be used for hot water applications or in my opinion just use PEX pipe.
Never
Most probably the "sediments" have settles to the bottom and as the hot water is taken off the top of the heater there will be none in the tap water. Hot water will contain less calcium and other impurities (they fall out and become those "sediments" but hot water may also dissolve other compounds from pipes. I use hot tap water in my coffee pot.
F, for frio (cold). Unfortunately, the hot water tap is marked C, for calor (hot), which could cause confusion. Fortunately, many taps use a color code as well : Red for hot water and Blue for cold water.
There is no "one" specific answer to this as it depends if it comes from an "on demand geyser", "gravity fed geyser" or "high pressure geyser" and the distance between the geyser and the tap
yes it can use
UPC does not permited PVC to be used for potable hot water. So don't put it inside the house. IF you have o use plastic pipe use PEX of CPVC both of which are OK for hot potable water. In answering you question PVC can handle 120 degree water temps
Chlorinated Polyvinyl Chloride (CPVC) pipes can withstand heat up to 180 degrees. A special glue is used to blond it together. PPR pipes are a made of plastic and uses no glue as it is heat-fused. PPR is a commercial product.
No most certainly not. In most countries this is illegal and you will be prosecuted if found guilty. Always use metallic pipes for hot water, inlet or outlet.