yes you can a lot!
It is best to use a white vinegar/water (50%/50%) combination to clean ceramic tile floors. It really works!
soak with water until it softens and thegently scrape
You don't need to seal ceramic tiles if you use epoxy grout you will be fine with the high traffic
Sealer is applied on top of the glaze & does not penetrate the glass Glaze, so over time & with use & cleaning it will wear off. so YES!
It all depends on the sealer you used! I use a product called StableCrete that penetrates into the grout joints to waterproof them without leaving a film. Ready for light traffic in four hours. The Grout is what you seal with a ceramic install and not the ceramic!
You can use Loctite power Grab to bond ceramic tile to concrete. However, it would be very expensive and take longer as it's in a tube. There are many tile cements in buckets that would cost MUCH less and be faster to use. I would use Loctite only for tile repairs.
Tile has a glass finish & doesnt need wax, Wax can cause a slip & fall hazard when it gets wet Sealing tile is a misnomer, you really only need to seal the GROUT.. stop by the Depot & get some grout sealer, better for the grout
No, turpentine is actually used in painting wall tile. It is quite abrasive though. Use sparingly and be careful not to touch surrounding furniture or fabrics.
Porcelain is usually sealed already. You then add sealer to the grout.
Yes, but it will destroy the layer of mfg sealer and will always take on stains. If you are trying to do this so you can adhere something to it,use a high % etcher and etch 2 times.
Yes. If it is a ceramic or porcelain tile you only need to seal the grout. If you have a natural stone or quarry you need to seal the tile and the grout. Generally when you install natural stone, you seal the tile before you grout. Otherwise the colorant in the grout will seep into the tile. If the floor is existing you would seal it all at once. Don't forget to use a stripper to remove any old sealer. Make sure the stripper is acceptable for the type of flooring you are sealing. Stone can be very delicate and damage easily. Vinegar can etch marble, granite, and travertine. One last note, you get what you pay for with sealer. Invest in a good sealer and you will get much better, much longer results.
yes