It is possible to put a 6 speed back wheel on a 21 gear bicycle but you will never be able to use more than the 6 gear allowed by that cassette sprocket.
The best way to take advantage of the 21 gear bicycle is to change that 6 speed cassette sprocket and replace it by a 7 speed cassette sprocket. This way you will keep that back wheel and also be able to use all 21 gears of your bike.
First off, give up this 18/21 speed nonsense. Tha may be how many dealers label their bikes, but if you gonna mix n' match you're better off referring to the number of rear sprockets. 18 speed can be both 2 front and 9 rear(2x9) or 3 front 6 rear(3x6), with your 21-speed is a 3x7.
Anyhow, a 3x6 is limited to a design called a freewheel, where the mechanism that allows you to coast is integrated with the sprockets.
A 3x7 can be either a freewheel or a freehub(where sprockets and coasting mechanism are treated as separate pieces). And yoy can't put sprockets from a freehub wheel onto a freewheel wheel.
If both the 3x6 and the 3x7 are freewheels then you can move the freewheel (= the sprocket pack) from one over to the other. But the 7-speed freewheel takes up more axle space than the 6-speed, so you'l likely have to add some spacers.
I'll post a link where there are nice pics and explanations on how to tell them apart.
check the side stand switch , this cuts out the engine if it (the side stand) is down when you put the bike in gear .
it means...that all the gear of bike can put in clockwiswe direction...i.e back side
in the engine
Four of them.
no i dont think you do but do you know if you can put a yak wheel on the back of the scooter
neutral
You unscrew them from one end and screw them on at the other. You may need a socket wrench and an extender. Remember to put the wheel nuts back on.
Kinda, sorta. You can certainly (have someone) build a BMX wheel around a fixie hub. I suppose you could somehow disable the freewheeling action of a regular hub too, but I wouldn't recommend it. Putting back pressure on the pedals on a bike that hasn't a real fixie hub can cause the sprocket to unscrew.
The neutral position is usually between first gear and second gear. Put the bike in first gear then push up that should put it in neutral.
If it is a Yamaha Bruin 250, 1. Stop the bike. 2. Keep the FOOT Brake and the RIGHT Hand Brake compressed. 3. Shift the bike into 1st (FIRST) gear. 4. Grasp the Forward/Reverse lever on the upper left side of the bike and move it left then down (towards the rear of the bike) and then move it right into Reverse. The red light (R)between the handle bars should come on. 5. LOOK BEHIND you before depressing the throttle slowly to back up. Reverse step 4 to put the bike back in Forward gear.
loosen the 2 back nuts, then if you are able to pull the wheel back so that it is tight again. if that dosent work buy a chain tensiner (tightener) and take off a link on the chain then put the chain back together and chuk it bak on ya bike!
First you need to get the Mach Bike from the bike shop.Next you need to put the bike in the fastest gear and there you go.But make sure you do not lose speed.