Answers.com > Wiki Answers > Categories > Cars & Vehicles > Auto Parts and Repairs > Car Electronics and Lights > Car Batteries > DIY installation of a voltage stabilizer 2001 BMW e46 325i- How should I connect it Do I connect it to the battery in the trunk or under the hood to terminals?

DIY installation of a voltage stabilizer 2001 BMW e46 325i- How should I connect it Do I connect it to the battery in the trunk or under the hood to terminals?

In: Car Batteries, BMW 3-Series [Edit categories]

Answer:

Connect it to the battery under the hood. You want to put it closest to where the noise is being produced.

First answer by ID0000000000. Last edit by ID1198068428. Question popularity: 1 [recommend question].

[report abuse]

Can you answer these Car Batteries questions?

	Who and when was the car battery invented?	Answer it!
	Do you need to disconnect electric alternator and battery when welding on Dakota truck?	Answer it!
	Why do the lights flicker?	Answer it!
	Can you charge storage of a car if not collected?	Answer it!
	What do you plug a foot throttle in to on a electric motor?	Answer it!

Which battery terminal do you connect first?
Positive.
How should you connect the battery to the car?
Connect the negative cable first.
Which terminal of bulb does connect with battery?
Center terminal is connected to the positive from the battery. Outside is connected to ground (-).
Trunk release 2001 BMW 325I?
It is down on the kick panel in front of the drivers door.
Where should I connect the ground wire on a vehicle battery?
That depends on the vehicle. Some use negative ground and some use positive ground. Most modern cars (after 1970 or so) use negative ground electrical systems, but it's best to check the manual for...