Just had light come on and code read as P0014. Definition of this is a cam phasing error. Explanation is "The ECM has detected the camshaft phase angle has exceeded its tolerance value". I have my list of probable causes but wanted to know if these are popping up for Chevy's and if so what is the usual problem? Is it a sensor or something else mechanical? I have had no problems with the engine, everything sounds and runs fine, can I still saefly drive it? Just had mechanic look it over a week ago and give it the thumbs up on everything is fine. remove the cam phaser solenoid valve and check the screens for a restriction. This code usually comes up on vehicles that don't get regular oil changes
" Camshaft Position - Timing Over-Advanced or System Performance (Bank 1)
symptoms
Hard starts
poor idle
stalling
cause
wrong camshaft timing
Wiring issues (harness/wiring) in intake timing control valve control solenoid system
Steady oil flow to VCT piston chamber
Faulty timing valve control solenoid (stuck open)
The fix
Replace the VCT unit or one of its components
This code is for the exhaust cam actuator timing system. There are a few things that can cause this. Anything from the actuator solenoid, to the actuator, to an internal engine problem. - Tech JK ---------------------------
Trouble code P0014 means: "B" camshaft position - timing over-advanced (Bank 1)
what does code p1537 on a ford mean
diagnostic code 8820
" Camshaft Position - Timing Over-Advanced or System Performance (Bank 1)symptomsHard startspoor idlestallingcausewrong camshaft timingWiring issues (harness/wiring) in intake timing control valve control solenoid systemSteady oil flow to VCT piston chamberFaulty timing valve control solenoid (stuck open)The fixReplace the VCT unit or one of its components
Misfire code
The Ford diagnostic code 316 is a misfire detected at engine start up.
po544
Trouble code P0730 means:Incorrect gear ratio
have p1032 code what does it mean v70 Volvo 1999
Nothing. All of the diagnostic codes consist of 2 digits. 'Code 3' must be incomplete.
As you do not list the code you are reading, it is impossible to answer your question.