Switches and Bridges are pretty similar, both operate at the Data Link layer (just above Physical) and both can filter data so that only the appropriate segment or host receives a transmission. Both filter packets based on the physical address (AKA MAC - Media Access Control - address) of the sender/receiver although newer switches sometimes include the capabilities of a router and can forward data based on IP address (operating at the Network Layer) and are referred to as IP Switches. Often the desired results could be achieved using either a switch or a bridge but *in general* bridges are used to extend the distance capabilities of the network while minimizing overall traffic, and switches are used to primarily for their filtering capabilities to create multiple, smaller virtual LAN's out of one large LAN for easier management/administration (V-Lan's).
The main difference between them is --->
Bridge can connect only TWO networks/ LANs/ Hosts, means bridge has only TWO ports. While...
Switch can connect more than TWO networks/ LANs/ Hosts because switch has more than TWO ports.
Or you can say that a bridge with more than TWO ports is known as a Switch.
The IEEE specs define bridges... and those bridges have tons of ports, not just two. The difference bridge/switch is mainly marketing.
A switch is a device that connects clients together in a local area network.
A bus is a network topology, which describes the wiring used to connect clients together. A bus is not a device, and a switch is a device.
Actually no difference, bridging is one of functions supported by modern routers (wireless switches).
Unlike switch, bridge has the ability to connect lan with different IP subnet even different class.
The difference between an ethernet bridge and a switch is that the bridge only has two ports, while the switch has multiple ports. When there is a lot of traffic going through the ports, the bridge traffic may get tied up or crash often because there are only 2 ports for information to travel back and forth.
Boxgirder bridge
no difference whatsoever
giant cables and abutments
There are no similarities between the two bridges. They are completely and totally different.
The span is the distance between supports. The sum of the span lengths is the bridge length.
AbutmentA retaining wall supporting the ends of a bridge or viaduct.Pierssupport if continuous bridge
go to www.howstuffworks.com
one is your mom
There is no great difference between between the two in principlebut,In a Carey foster's bridge there is no end resistance whereas in the case of a metre bridge end resistance afffects our readings.Hence Carey foster bridge is more accurate than metre bridge .Carey foster bridge can also measure low resistance and high resistance but a metre bridge cannot do so.
The different between suspension bridge and beam bridge are beam bridge are for short distance but suspension bridge for long distance. Beam bridge are used for highway passes and suspension bridge for wide waterway passes.
The people from the South will have a slightly different accent. Y'all ;-)