Answers.com > Wiki Answers > Categories > Technology > Engineering > Electrical Engineering > Differentiate delta to delta connection of the transformer to delta to Y connection?

Differentiate delta to delta connection of the transformer to delta to Y connection?

In: Electrical Engineering, Electrical Wiring [Edit categories]

Answer:

In delta to delta there will be no ground on both primary and secondary sides. Leave the primary side but we take care on secondary side. If there any fault occurs on the secondary then there will be unbalanced voltages between the phases results in the flow of current through the secondary windings so only we are using star on the secondary side while having neutral to prevent such a current flow.

First answer by ID2057608914. Last edit by ID2057608914. Question popularity: 3 [recommend question].

[report abuse]

Can you answer these Electrical Engineering questions?

	What is a star delta starter?	Answer it!
	What is welding current and welding voltage?	Answer it!
	What is service breaking capacity for a short circuit?	Answer it!
	Why should the transformer frequency be constant?	Answer it!
	Does an increase in resistance will cause the heater to generate more heat?	Answer it!

Relevant answers:

Differentiate star to delta connection of a transformer?
Star has one red, one yellow, one blue and neutral phases seperatelly. Delta has all four in sequence, combined.
Advantages of Delta connections in Transformers?
1. A three phase transformer with HV side star connected and LV side delta connected results in economical design. 2. However, if star winding is required on the LV side due to load / safety...
When is a motor in star connection or in delta connection?
Star (or wye) connection is where each of the three phases has a fourth conductor, neutral, as its current return. Current flow in this configuration is phase to neutral, which is also grounded back...
Where do you ground a delta delta transformer?
In a delta-delta transformer, none of the actual conductors are grounded, directly or indirectly. You do, however, always ground the casing. This is protective earth ground, or PE ground, as opposed...
Where is the neutral point in delta connection?
There isn't one.

Differentiate delta to delta connection of the transformer to delta to Y connection?

Related questions: [Edit]

Can you answer these Electrical Engineering questions?

Relevant answers:

Related ads:

Related videos:

Home

Featured topics:

Local Businesses

Answer these

Recent questions

Featured guides

Site

Company

Community

Updates

International sites