It is very simple. Raise the Durango, remove the pan bolts, and the filter will be exposed. Simply pull down the filter, replace the filter. Be sure and purchase a transmission filter kit which will come with a pan gasket and filter. Be sure to scrape the old gasket from the rim of the pan. If not, it will not properly seal. It is very simple. Bare in mind, there is no drain plug for draining the Transmission Fluid. Crack the bolts, and remove one side of the bolts slowly. The fluid will begin to drain. Only after fluid has drained can you remove the pan. Also keep in mind, there will be some fluid in the pan when you remove it too. Use caution
Call the cops or break the window
You don't, that's why timing belts and chains are replaced with certain mileage intervals regardless.
It is next to the blower motor underneath / behind the glove box. It is held on by two screws and has a 4 or 5 wire electrical connector plugged into it. you will find it in the air box, inexpensive to replace. I jury rigged mine for a month by driving a screw through the area that had the break in the printed circuit resister. High speed bypasses the resistor pack so at least that is always available in the meantime.
I had the same issue and it turned out to be that the break caliper was sticking and needing replacing.
Short or break in the wiring somewhere between the relay and the pump, or maybe the pump solenoid isn't grounded properly.
pretty much everything will break it is a dodge
It is in the top of the rear axle. Remove the nut and bolt, gently twist around and pry up slowly to remove. Be carefull not to break off in the axle.
somtime if you unlock the passenger side door with a working key it will shut down the alarm it works on a Cherokee i know never tryed on a durango good luck.
P1414Secondary Air Injection System Monitor circuit High Voltage Air pump is shot. Looks like it's time to break out the meter and a wiring diagram! good luck!
on my 2001, if the same, the paneling just pulls off. i believe you start form the side. you can try feeling around with a screw driver or something thinner for the clips. just as long as you don't he-man it and break it off
Break a window duhhhhhhhhhh
you have to do it from the inside ...pull the light out careful not to break the tabs .after you pull the light out the cover will pull out at the center enough to get your arm back behind it reach down by the latch at push the white tab toward the latch ....once thats done it should open !!!