Answers.com > Wiki Answers > Categories > Cars & Vehicles > Auto Parts and Repairs > Fuel and Engines > Fuel and Fuel Intake > Fuel Pumps > Do you need a fuel strainer on fuel pump on 1985 corvette?

Do you need a fuel strainer on fuel pump on 1985 corvette?

In: Fuel Pumps, Chevy Corvette [Edit categories]

Answer:

yes definitely. if any sediment,dirt or debris hits the vanes on the pump it will jam it and fail.also called fuel sock

First answer by Gspeedshop. Last edit by Gspeedshop. Contributor trust: 5 [recommend contributor ]. Question popularity: 1 [recommend question].

[report abuse]

Can you answer these Fuel Pumps questions?

	What does the fuel inertia cutoff switch do?	Answer it!
	How do you test if fuel relay is bad?	Answer it!
	Where is the fuse of fuel pump relay on Mercedes W124 E220?	Answer it!
	How do you do flushing of car fuel tank?	Answer it!
	Does crankshaft position sensor keep the fuel pump from working on a cavalier Z24?	Answer it!

How do you change the fuel pump on a 1985 Corvette?
its very simple just take the gas door off and remove the 8 10mm bolts holding the sending unit in remove fuel lines and sending unit takes about 3o min 1) disconnect neg - on battery 2) remove gas...
Where is the fuel pump relay 1985 corvette?
fuel pump is in the fuel tank it is remove trough filler neck not that bad of a job
1985 corvette where is the fuel pump located?
In the gas tank. Remove the fuel door, there are four screws[should be torx]. Under the boot are the fuel lines. You will need to remove the boot, and it will probably rip. Carefully remove the hose...
Where is the fuel pump relay on a 1985 corvette?
The fuel pump relay on a 1985 corvette is mounted on the firewall under the hood on the driver side. Just to the right of the wiper motor.
Is fuel pump relay same as fuel pump strainer?
no the relay sends power to the fuel pump,the strainer sits on the bottom of the pump its like a little fine filter so you dont suck up crap from the bottom of the fuel tank