The 1965 came with lap belts for the front seat only. This was a new law for 1965 and only required front belts.
There should be seat belt mounting points on the floor under the back seat.
It's a bench seat with two seat belts
Actually the seats will fit inside the camaro but you wont have any seat belts. The seat belts in a coupe are mounted in the roof and the seat belts in a convertible are mounted on the sides of the seats. so the seat will fit but you will have to buy some seat belts or use your old ones. The back seats should have no problems tho. I have a 2002 Camaro.
drivers side valve cover, towards the back
You could order anything back in 65.
Any convertible with a back seat.
Behind the back seat
Long shoe on back side, short shoe on front side, what else do you need to know?
Of course it's possible. However, the back seat will have to come out and that is not fun. The back rest of the seat comes out as one unit. Make sure you mark areas for re-alignment during reintallation
Convbertible tops, as a rule, have hydraulic pumps that are located up near the back of the rear seat. these pumps should have an acess plug for refilling. Bleeding for air may be required. Good Luck.
The switch should have a chrome bezel (a big nut) that screw on the front of the switch to hold it to the dashboard. Unscrew this and it will come out from the back. It will have a connector that will unplug from the rear of the switch.
seat belts: 4 2 in front and 2 in back