Is it an earbud, because if it is than yes. It should fit regardless, but most likely if it is an earbud.
no, it doesnt
It depends on what you mean by a 30 pipe. Is 30 the cross sectional area - in which case, what is the length of the pipe? Is 30 the length - in which case, what is the cross-sectional area?
I doubt that you would manage to fit a V6 engine in a Corsa without cutting more than the rear bumper.
Large pipe wrech...unscrew and screw new one on!
2*pi*r*L where r is (outer) radius of the pipe (in case of the outer surface) nd L is the length of the pipe.
Power steering cooler.
Yes, the tail pipe should extend 2" to prevent carbon build up on the vehicles rear fender and bumper.
If you're asking what the term stove pipe means, it's when the empty case of a fired cartridge is protruding from the ejection port.
Very depend on the application, concentric pipe had lower pressure drop and better flow distribution. However, in many case, eccentric pipe reducer is installed on propose to allow liquid drainage from reducing in horizontal pipe.
On the right rear of the tractor above and to the right of the PTO shaft. Looks like a piece of pipe with a pipe cap and vent on top.
This will depend on the car and the hitch kit. The Hitch I put on my Fiero to pull the rase tire trailer to events was a bolt on in two hours affair. The one for my KIA is going to be a pain, the rear bumper cover is removed, the bolts to hold the metal bumper to the car are removed, the tail pipe removed. The hitch is bolted up and holes drilled for extra bolts, all the bolts are loosened off and the hitch allowed to hang, the bumper cover re-installed, the hitch bolts tightened and the new tail pipe hanger installed. Book says 3.5 hours, at home in the garage all day.
pipe it where? to a textfile? in that case its simple, use the ">", lets say your program you want to pipe output from is called "myfile.exe" then in a cmd windows, you just type: myfile.exe > sometextfile.txt and it will run and output its spew to that file instead of the console... or lets say you want to pipe a directory listing, then its dir > mydrive.txt