0
Yes
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Do you need a radio code to replace the factory radio with a new CD player in a 1999 grand prix?
No, you dont need the code if your gonna put in an aftermarket deck. The only time you would need the code is if you took the stock radio out and unpluged the harness, so its not a problem with a new radio.
Can you take a dash from a newer silverado like a 1996 and put it in a 1994 silverado?
It is possible, but there is a large difference in the dash/wiring/etc. Besides the dash, the wirhing harness for the dash as well as the harness for the motor and the radio harness will need to be changed.
What causes a radio to run down your battery?
if your radio is not stock then the wiring is not correct or depending on the year you may need a specific wiring harness for the car which can be bought and installed by any extreme audio store. that would be the case if your car radio stays on when the car gets turned off. It uses energy
Does anyone have the speaker drawing or can tell me the colors for a '07 Nissan Frontier I need the speaker wiring not the radio wiring colors since the colors are different at the speakers?
stock wire harness speaker wires are always Gray, White< purple< green
How do you remove the 2002 Chevy Avalanche factory radio and install a after market one?
FIRST REMOVE THE TRIM PIECE THAT RUNS AROUND THE WHOLE DASH. IT POPS OUT, BUT BE GENTLE ENOUGH NOT TO BREAK IT BECAUSE IT IS PLASTIC. THEN ON THE LEFT AND RIGHT SIDE OF DELCO RADIOS THERE ARE TABS THAT YOU PUSH DOWN AND IT RELEASES THE RADIO. PULL THE RADIO STRAIGHT OUT. YOU WILL HAVE TO REMOVE THE ANTENNA PLUG FROM THE BACK OF THE RADIO AND THE WIRING HARNESSES FROM THE BACK OF THE RADIO. FOR A NORMAL DIN RADIO REPLACEMENT YOU WILL HAVE TO PURCHASE AN ADAPTOR KIT FOR THE OPENING. YOU CAN PURCHASE THESE AT ANY STEREO SHOP OR WAL-MART, OR RADIO SHACK. YOU WILL ALSO NEED TO PURCHASE THE ADAPTOR WIRING HARNESS TO FIT YOUR VEHICLE SO YOU DONT HAVE TO SPLICE ALL OF THE WIRING TOGETHER. MATCH THE WIRING FROM YOUR REPLACEMENT RADIO TO THE WIRING HARNESS AND MOUNT THE RADIO IN THE ADAPTOR KIT. INSTALL THE RADIO INTO THE OPENING AND PLUG ALL OF THE WIRING BACK TO THE FACTORY PLUGS. REPLACE THE TRIM RING BACK ONTO THE DASH AND YOUR DONE. ABOUT AN HOUR TO DO EVERYTHING IF YOU HAVE EVERYTHING READY TO GO. HOPE THIS HELPS!!!
What is the car radio wiring for 1996 Plymouth breeze?
Go buy a wiring harness. It clips right in to the old wiring, and only takes about 3 seconds. Its about 15 dollars, and you only need to wire the new harness to the new CD player/radio, and the colors will match.
Radio wiring color diagram for 2008 Chevy Cobalt?
you need the proper wiring harness to change the stereo in a cobalt or the security features will kick in once you have the proper harness you just have to match wires
How do you wire up a after market radio on a 2005 1500 dodge pick up he factory plug has been cut off the wiring harness?
Unfortunately you would need the wire harness. So either get a new harness or a new radio.
How do I change the factory stereo in my 2004 Hyundai Sonata?
you need to pop out the frame and unscrew the radio. You will need a wiring harness for an after market stereo.
Need a radio wiring diagram for 1989 GMC Sierra Radio?
Battery RED + (+) IGNITION SWITCH HARNESS Accessory01 ORN + (+) IGNITION SWITCH HARNESS Ground BLK - (-) RADIO HARNESS Illumination GRY (+) RADIO HARNESS FrontLeftSpeakerPos TAN FrontLeftSpeakerNeg GRY FrontRightSpeakerPos LT.GRN FrontRightSpeakerNeg DARK GREEN RearLeftSpeakerPos BRN RearLeftSpeakerNeg YEL RearRightSpeakerPos DK.BLU RearRightSpeakerNeg LT.BLU
What is needed to install a new radio in a 1994 Dodge Spirit and is there a installation kit?
To install a radio you need a wiring harness for a 1994 Dodge (a Metra 80-1817 from Circuit City is what I used), and an installation kit (make sure it fits a 1994 Dodge Spirit). You'll probably need to splice the wires from the wiring harness to the stereo harness unless you can get find the right kind of connection somewhere.
Need wiring harness to swap 2.9 to 4.0 v6 1989 ford bronco II?
get the wiring harness from the explorer or donor vehicle that you get the 4.0 from, you need the harness from the 4.0!!!
Do you need a radio code to replace the factory radio with a new CD player in a 1999 grand prix?
No, you dont need the code if your gonna put in an aftermarket deck. The only time you would need the code is if you took the stock radio out and unpluged the harness, so its not a problem with a new radio.
Can you take a dash from a newer silverado like a 1996 and put it in a 1994 silverado?
It is possible, but there is a large difference in the dash/wiring/etc. Besides the dash, the wirhing harness for the dash as well as the harness for the motor and the radio harness will need to be changed.
Trying to install a sony explod car radio in a ford windstar lx 2002 but the harness my car is from a pioneer radio and the colors are different than sony explod wire harness?
Yes, the new stereo wiring is always going to be different.What you really really need to get is a wiring harness that will make it so much easier to "bridge" from the van wiring to the new stereo wiring, and most importantly allow you to do this without cutting the factory wiring!There are a number of good sources for these inexpensive harnesses - nearly any auto parts, where you bought the radio, heck, even Walmart carries a good variety of them.See "Related Questions" below for more about installing a new radio...
What causes a radio to run down your battery?
if your radio is not stock then the wiring is not correct or depending on the year you may need a specific wiring harness for the car which can be bought and installed by any extreme audio store. that would be the case if your car radio stays on when the car gets turned off. It uses energy
Best harness kit for 2002 f 150?
Need more info. harness wiring for what?
