you can't- the hinge is bent, cougars have very heavy doors mine sags also Or buy Hinges & replace the old worn out ones. I did mine.
The bolts go into a plate in the door and the door post, not solid holes in either. The plate will move up and down, side to side a little bit. Loosen the bolts and adjust as needed.
There are screws to adjust them just above the light assy.
The way you open a Mazda 2 drivers door when it is jammed is by removing whatever is making it jam. You may need to take a screwdriver and slide it down the door to unjam it from the door frame.
The gas tank opener for the 86 Fiero, is located on the "B" pillar,located behind and to the left of the drivers seat approximately 3 inches back from the door opening, and four inches down from the roof. It is a pull down hook.
There is a lever on the left side of the drivers seat that you can pump up or down.
When a door drops down it usually is bacause it needs a hinge bushing. However, if everything's OK there's two things you can do. 1. Easiest method. Put a jack underneath the door and bend it back up. Unless the hinge has slipped, that's why it's down there anyway. 2. If applicable, loosen the hinge and adjust the door up.
Push all the door locks down manually and then lock the drivers door with your key if it will not stay locked when you push the lock down and shut the door.
You can adjust your 2004 Ford F1 50 door with the retaining bolts on the door. Loosen the retaining bolts and the door will slide up or down.
It is down on the kick panel in front of the drivers door.
You have to lock the car with a key. You can't push the lock down with the door open if you have power locks. They do this so that you can't lock your keys in the car.
on the drivers door, in front of the rear hatch release. its down low towards the front of the car.
You are not serious are you? Its down on the drivers side just above where the arm is to open the hood. There is a plastic door there. Use a small screw driver to pry the door down and there it is!