0
1982-1994 Chevy Cavaliers
500 Questions
What are the steps in replacing an ignition lock cylinder on a 1990 Cavalier?
Asked by Wiki User
Hate to tell you this, but you have to take the steering column apart. under the horn there's a bolt, but you need a special tool to put it back on... took me about a day and a half to fix it up on mine and now it just needs fixing again... so I just bought a club and hoped nobody found out it wouldn't lock.
How do you change the front and rear speakers and the audio deck in a 2000 Chevy Cavalier?
Asked by Wiki User
if you send me an email i will be able to tell its kinda tricky because you have to remove the top panel of the dash to take out the stereo and you dont want to deploy the airbag in the process, my email is bigclop2@yahoo.com
How do you replace a fuel pump in a 1991 Chevy Cavalier?
Asked by Wiki User
The fuel pump is located in the fuel tank as with virtually all cars nowadays. There is a certain degree of danger working on or around a fuel tank. But, if you want to do this yourself, You will need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
or you can go to www.auotzone.com and go to repair manuals and it will show you exacly what to do and you can print it if you need to
How do you remove non-Bose rear speakers from a 1997 Nissan Maxima?
Asked by Wiki User
I have had to remove the lower section and upper section of the back seat to start this process. To do this slide your hand along the bottom edge of the lower seat until you feel a ring, now pull this towards the front of the car (Remove lower section of seat from car now). Next there is a screw on both bottom sides of the upper seat section that connects the seat to the car, Remove these two screws. Now I found two more screws inside the panel that folds down in the middle of the upper section of seat. Lower the panel and pull the fabric retainer up and away from the trunk wall. These two screws were in the car at a ridiculous tightness, I literally had to get my biggest screw driver to turn these out. Once these screws are out then the seat is free and remove from car. Now the reason these need to be removed is because Nissan mounted the speaker grills right to the rear window deck. In order to remove this you need to remove the seats, and now the side panels that sit next to the rear window and hold down the rear window deck. These come off fairly easy, Just start at a corner and wiggle and pull until each bracket seperates from the car. Now the rear window brake light needs to be removed in order to remove the rear window deck. This I have not figured out yet how to remove without just breaking it off out of frustration (hence the reason I'm on the net looking for answers.)
UPDATE by 6eStanza
To complete the removal of the rear deck to access the speakers below, you need to crawl into your trunk with some pliers and a flashlight. If you look up to where the speakers are you should see a couple of white retaining clips. If you squeeze the exposed end with the pliers (careful not to break clips) and push up on the deck simultaneously you should be good to finish your project. Thanks a lot Nissan for making that so flippin complicated.
The center brake light mount is actually removed by turning the whole assembly counter-clockwise about 1/8 of a turn.
Try to use the Nissan speaker adapters plugs so you don't need to cut wires and mess up the electric system, you can get those from eBay or amazon.
Do they still make springmaid towels?
Asked by Wiki User
Don't think so. I've been trying to find a replacement without luck.
