Chevy G20
Manufactured by the American automaker General Motors Company for the G-Series product line, the Chevy G20 was a passenger van powered by a 4.3 liter V6 engine, which can generate up to 165 horsepower.
Total questions 3700
Follow
ID2914815925
asked What was Hummurabi's Code and said it was different from 92 g20 Chevy 5.7 looking for trans code you were told code m30 was the code 4l60e but your build code in dash don't have m30 so what other code number could it be 26 May 2012 13:59
ID1263813873
removed How do you fix rough idle on a 1995 Chevy G20 van from Chevy G20 24 May 2012 08:08
ID1815654515
added What is the R134a fill capacity for a 1988 Chevy van with a rear unit to Chevy G20 24 May 2012 05:00
Organization
RoyR17-19 mpg
Popularity: 8 • Tools: Recategorize
The spring holding the door button in place has fallen out. Remove the door handle and replace.
Popularity: 8 • Tools: Recategorize
Yes, there is a nylon ``sock`` on bottom of fuel pickup.
Popularity: 8 • Tools: Recategorize
Go to AUTOZONE.COM "do it yourself" tab and enter your specs.
Popularity: 8 • Tools: Recategorize
you have to have a diagonstic reader to reset the light. Before you reset the light make sure there is nothing wrong with the abs...
Popularity: 8 • Tools: Recategorize
If it's a 350ci the firing order is 1-8-4-3-6-5-7-2
Popularity: 8 • Tools: Recategorize
usually on the left of the engine between the first two spark plugs
Popularity: 8 • Tools: Recategorize
air filter, spark pluggs wires dist cap rotor oil change , then place on diag machine, wait for results
Popularity: 8 • Tools: Recategorize
Not hard under the dash remove the pannel there will be 4 bolts holding it up on the dash and under the carpet on the floor will...
Popularity: 8 • Tools: Recategorize
Depends on the engine and how you drive. I've seen some rated at up to 16 mpg, but I usually get 10-12 mpg with my 305 V8.
Popularity: 8 • Tools: Recategorize
It should be underneath the van, on the passenger's side, just before the rear wheel.
Popularity: 8 • Tools: Recategorize
It doesn't want to, It's not done running yet... :) Check the ignition timing with a timing gun. When the engine...
Popularity: 7 • Tools: Recategorize
my 91 van started running rough and then just stopped. After about 45 minutes it started up again. IT DID THIS TWICE IN THE...
Popularity: 7 • Tools: Recategorize
Popularity: 7 • Tools: Recategorize • Needs Answer
I had this same problem and went crazy looking for a bad relay. Apparently there ISN'T a horn relay for the G-20. Probably you...
Popularity: 7 • Tools: Recategorize
I would think it's for your tv.Your rack acts as your antenna.
Popularity: 7 • Tools: Recategorize
yes it can
Popularity: 7 • Tools: Recategorize
Sorry to say it but I've been looking for the same info for the longest. you should do what I'm gonna do, just get the rebuild...
Popularity: 7 • Tools: Recategorize
the v6 is a 2.8 litre engine i am asuming. the carb has a small line in the back that needs to go to the temp switch on the back...
Popularity: 7 • Tools: Recategorize
I get about 14 mpg highway.
Popularity: 7 • Tools: Recategorize
Have vehicle scanned to determine the problem - could be a plugged catalytic converter
Popularity: 7 • Tools: Recategorize
Should be 2 bolts (3/4 socket) & remove & replace
Popularity: 7 • Tools: Recategorize
You can go to your local Chevrolet dealership and pick one up for a price. Just a couple of bucks and you can old a reproduction...
Popularity: 7 • Tools: Recategorize
go to NAPA , buy the motor and instructions. the door handle is held by a U shaped clip. you can hook it with a wire or buy the...
Popularity: 6 • Tools: Recategorize
Take it to a pro. It's really hard to do yourself. You should be able to fix both motors w/ install for about $350.00.
Popularity: 6 • Tools: Recategorize
Popularity: 6 • Tools: Recategorize • Needs Answer
Figures from NHTSA crash testing list the 1987 Chevy G20 at 5456lbs, this should be close to the figure for the 86 model.
Popularity: 6 • Tools: Recategorize
On the bottom of the radiator.
Popularity: 6 • Tools: Recategorize
Integrated into the starter.
Popularity: 6 • Tools: Recategorize
AnswerLots of things to factor in on such a question- mileage/condition of motor, rear end gear ratio & driving habits to...
Popularity: 5 • Tools: Recategorize
Popularity: 5 • Tools: Recategorize • Needs Answer
It Sounds Like A Blown Head Gasket. Have A Compression Test Done On It By A Garrage, Also It May Not Be As Bad. Let Them Check It...
Popularity: 5 • Tools: Recategorize
I don't know but cannot get mine to go out, bakes are fine , any ideas?
Popularity: 5 • Tools: Recategorize
Popularity: 5 • Tools: Recategorize • Needs Answer
Front or rear?
Popularity: 5 • Tools: Recategorize
ls is trim lee it should be marked on an exterior tag or maybe the owner's manual.
Popularity: 5 • Tools: Recategorize
Possibles: 1)Plugged fuel filter 2)Gas guage incorrect reading & no fuel in tank 3)Fuel pump not working 4)leak in fuel...
Popularity: 5 • Tools: Recategorize
a side goes to engine
Popularity: 5 • Tools: Recategorize
Carefully. Why would you bother?
Popularity: 5 • Tools: Recategorize
Starting from the front (the front is where your radiator fan is located) driver side (#1 cylinder), it alternates back and...
Popularity: 5 • Tools: Recategorize
Popularity: 4 • Tools: Recategorize • Needs Answer
It should be at the fuel fitting to the carburetor, or more specifically, inside or behind the fitting. It's a small pleated...
Popularity: 4 • Tools: Recategorize
It is integral to the main ECU
Popularity: 4 • Tools: Recategorize
The turn signal switch overrides the brake light circuit while the turn signals are on. If the switch is damaged or worn out the...
Popularity: 4 • Tools: Recategorize
Check to see if it a factory recall first. I have a '95 Astro 4.3L V6 and it had a recall for the wiper motor because they would...
Popularity: 4 • Tools: Recategorize
Well, define 'fix'? If it is 'sticking', you can use white-lithium bearing grease injected (in moderation) with a 12-cc syringe...
Popularity: 4 • Tools: Recategorize
if u mean midshaft bearings on the drive shaft, then that is a bearing in the middle of the drive shaft.it will be near the...
Popularity: 4 • Tools: Recategorize
This is a fun one. It is in the tank so you have to drop the fuel tank to get at it. 1)run it out of fuel 2)secure vehicle on...
Popularity: 4 • Tools: Recategorize
"a threaded hole right above where the oil filter screws in" - Off the top of my head, I would guess that it is the hole for the...
Popularity: 4 • Tools: Recategorize
I have a 1992 and there were multiple engines available in that year. 4.3 V6, 305 V8, 350 V8, 6.2 V8 Diesel
Popularity: 4 • Tools: Recategorize
I get around 17 mpg with my g20 with the 350 motor \3.42 rearend
Popularity: 4 • Tools: Recategorize
You have to repace the pump. The jam up is plastic peices from inside the pump itself. Pick one up at the bone yard if you can....
Popularity: 4 • Tools: Recategorize
Drivers side, back of motor, all the at the bottom. You should be able to see it from up top, with the hood open, however, to...
Popularity: 4 • Tools: Recategorize
Popularity: 3 • Tools: Recategorize • Needs Answer
had the same problem with my 1988 g20 van it is the ground wire on the blower where it connects to the blower itself take out the...
Popularity: 3 • Tools: Recategorize
it gets 34 miles to the gallon
Popularity: 3 • Tools: Recategorize
It can be complicated, but if you have any knowledge of vehicles it will be easy. First you must take all the screw out that hold...
Popularity: 3 • Tools: Recategorize
Popularity: 3 • Tools: Recategorize • Needs Answer
its a big engine with many parts. its 1986!. When she warm she go any where as loomg as you dont heat up too much. an extremely...
Popularity: 3 • Tools: Recategorize
Popularity: 3 • Tools: Recategorize • Needs Answer
It's probably vent canister. Leave it there, it's important. Also, any dealership will B glad 2 educate U. Or, U can go 2 any...
Popularity: 3 • Tools: Recategorize
Use a funnel and add the fluids directly down the dipstick tubes.
Popularity: 3 • Tools: Recategorize
Popularity: 3 • Tools: Recategorize • Needs Answer
yes
Popularity: 3 • Tools: Recategorize
depends on acutal van..there all differant..should be printed in door jam..4500-5500lbs
Popularity: 3 • Tools: Recategorize
Assuming its a coversion van you need a thin open ended wrench about 1 3/4". looking just below the sliders you will see a large...
Popularity: 3 • Tools: Recategorize
There is no mistaking the sound a Diesel motor makes in comparision to a gas motor. If you listen to the motor and still don't...
Popularity: 3 • Tools: Recategorize
NO
Popularity: 3 • Tools: Recategorize
there should be a locking pin just on the backside of the handle. If you push in on the door just around the handle you shold be...
Popularity: 3 • Tools: Recategorize
help me preplace heater core in 92 Chevy van g20
Popularity: 3 • Tools: Recategorize
Chevy uses letters for models example G= full size van, C= full size 2wd pickup, K= full size 4x4 pick up. They use numbers for...
Popularity: 3 • Tools: Recategorize
diagram for a 92 Chevy van g20 Heater core
Popularity: 3 • Tools: Recategorize
Behind gauge cluster, right side of steering column
Popularity: 3 • Tools: Recategorize
The recommended tyre/ tire pressure for my 1995 Chevrolet G20 Conversion Van is 35 psi front and rear. This information is...
Popularity: 3 • Tools: Recategorize
The stock rear-end gear ratio for all US 240sx is 4.083
Popularity: 3 • Tools: Recategorize
That depends on when it shakes. Low speed, it could be a bad tire, bent wheel... High speed, it could be a bad tire, bent...
Popularity: 3 • Tools: Recategorize
Check on the door sticker to get the correct weight. Matters if your a cargo passanger or conversion van. Weight is all different
Popularity: 3 • Tools: Recategorize
It's in the gas tank. you'll need a pro unless your a good monkey.
Popularity: 3 • Tools: Recategorize
A verity is many diffferent things of something!
Popularity: 3 • Tools: Recategorize
1989 g20 van is passenger side under wheel well bolted on chassis
Popularity: 3 • Tools: Recategorize
i have an answer welcome pass is fhr6ytjf74hf7rdx
Popularity: 3 • Tools: Recategorize
I guess it's just for people to chat to friends and well, umm .. meet new people.
Popularity: 3 • Tools: Recategorize
The ones withot Carberators
Popularity: 3 • Tools: Recategorize
Most people think they came from France, but they actually orinated in Germany. They think that because of the french hair cut...
Popularity: 3 • Tools: Recategorize
I've got a '92 w/ the 350 and it's getting 13mpg. What are you getting?
Popularity: 3 • Tools: Recategorize
in 1912.in Germany.....you know the Germans all make good stuff.SHAMWOW.
Popularity: 3 • Tools: Recategorize
Can't give you exact numbers, but it would be a 4-speed auto w/ overdrive.
Popularity: 3 • Tools: Recategorize
under driver seat
Popularity: 3 • Tools: Recategorize
Clear or blackish water coming from exhaust is very common and is nothing more than condensation from the metal heating up. If...
Popularity: 3 • Tools: Recategorize
His name is Robert Manley. He's 39 years old, and lives in Lincoln, Nebraska. He was the primary designer and consulter for both...
Popularity: 3 • Tools: Recategorize
what are the timing marks on a chev 305 motor for the year 1995.
Popularity: 3 • Tools: Recategorize
Popularity: 2 • Tools: Recategorize • Needs Answer
Popularity: 2 • Tools: Recategorize • Needs Answer
i have a 95 6 cylinder and its 165432 with number 1 plug being on the front of driver side facing the front of the car...right...
Popularity: 2 • Tools: Recategorize
Its controlled by a vacuum hose
Popularity: 2 • Tools: Recategorize
