Plato died of natural causes in 347 BC at the age of 80. There is no record of his death being the result of foul play or murder.
you need a meter to find the resistance in your key. Then its in a small harness at the steering column. You need to cut one of the wires and attach the resitor to the cut wire going away from the column and the uncut one. I was in the alarm remote start business for years and years.
The Caddy STS Seville Came Out With a North Star Engine, And The Starter Is Under The Intake Manifold. It Is A Difficult Job To Replace. If You Are Not Well Adversed In Auto Engine Repair It Would Most Likely Best To Have A Good Garrage To Service It For You.
A broken blend air door is the most likely cause on a Jeep Grand Cherokee.
the best way to start out is to undo all the wiring on the intake, then take off your belt, alternator, alternator bracket,hoses,manifold,2 gas lines and power steering pump, then take off your valve cover and remove your push rodes and rocker arms and leave them in order from which you took them off then take off. then take off your head bolts and replace them to or else it will blow again then you should be able to take your head off, and heres a lil trick to help it from blowing, buy some aluminum spray paint and paint the gasket block and head right before you put it on and it will help the gasket seal.
i had the same problem with my car i had to change the fuel pump
have had to do this many times first i would check the fuel pressure regulator it is located in the fuel rail
remove the small hose, vacume line see if fuel comes out of it if so it needs to be replaced
on intrepid at the back of the motor hard to get that's where i would start if no fuel leaking out of the hose or the regulator then i would do a fuel pressure test cold and hot to see if there is a leak down problem for some reason the fuel is leaking into the intake making it hard to start hot good luck also could be fuel injectors fuel pressure should tell if you know how to do a leak down test
I bought a rebuilt unit from Detriot Axle on eBay for 145.00 w/ 35.00 returned to you after returning core. I had a good shop replace it for me at a cost off 250.00. They say you almost need a vehicle lift to do the job, and they have one.
Using 5W-30 oil in summer, my Catera's low oil pressure warning and light will come on when the engine is hot. But with 10W-40 oil this condition will not occur. Oil pressure gauge may indicate low pressure, but not enough to trigger the warning or the light.
Not to hard. Take off front black cover.
Take off top radiator hose.
Remove cooling fans.
remove front air bag sensor.
remove lower radiator hosei
Remove upper and lower cooling lines on both sides of radiator
Remove 4 top radiator cover bolts.
Remove radiator
Looking from the front down on the right hand side you have to remove the air filter box to access it. There is a hose that goes into a metal housing that splits the water flow in 2 directions. Remove the 2 bolts that hold the thermostat in the housing and pull back on the hose. Make sure to match your old one with the new one before you install it.
Google Kelly Blue Book and enter in the information such as condition and mileage, it's your best bet for an estimate
the front rotors easy, normal hand tools like he said, but im pretty sure the rear you need the tool to turn in the piston. you can't just squeeze them in with a c clamp or a pair of channel locks.
AnswerNormal hand tools, nothing special.
FOR YOUR REAR, GO TO AUTOZONE , RENTAL. 65.00, IF YOU RETURN THE TOOL, YOU GET YOUR MONEY BACK, AND IF YOU DONT, ITS PAID FOR WITH THE "RENTAL" FEE
where is location for fuse or whatever makes the turn signals work. they turn on but do not work
You have to take off the plastic intake cover there are a few screws holding it on. This will expose the front 4 plugs. To get at the rear 4 you will need to remove the spark plug coil packs, there are 4 bolds on this assembly I believe, then you can get at the back 4 plugs. Some of these may also need to be accessed from the bottom of the car, if you have big hands.
if the starter is spinning but not engaging then the bendix (starter teeth) is not moving out to grab the flywheel teeth or the flywheel has some broken teeth. The starter needs to be removed to see what the issue is.
The fuel pressure regulator in GM engines is very simple to rebuild. Just disconnect it from the throttle body and replace the gaskets. The parts are sold at any auto parts store. My experience is usually that there is a problem with the fuel pump, which causes low pressure at the regulator. Check the fuel pump first.
E 049 is " Air Injection Reaction (AIR) System Fault" For a full list of all codes, look here.... http://myweb.accessus.net/~090/dtcobd1.html Richard
The stereo wiring diagram is a drawing showing the structure and lines for installing Êcar amplifier, car radio, subwoofer or car stereo. The diagram saves you the time and headache of doing this task.
You need just basic hand tools, if you are not experienced with water pump replacement then you should let an experienced mechanic do the job.
Believe it or not, you might have 2 BURNT OUT LOW BEAMS. Ive seen that a few times.
How many approximate miles are left in that tank of gas.