answersLogoWhite

0

🚗

Dodge Caravan

The Caravan is a minivan produced by Chrysler Group LLC for its Dodge brand. Since its introduction to the market in 1987, this long wheelbase (LWB) vehicle was manufactured in five generation models.

500 Questions

What does a motormaster oil filter number 17-1723-6 fit?

User Avatar

Asked by Wiki User

I had an old motormaster filter in my garage but couldn't remember if it was for my 2000 Ford Taurus or my 92 Chev S-10. Here is what I found:

Couldnt find any thing with Google or Canadiantire.com, but

My motormaster filter 17-1881-8 has number below it "PH3600" which looks like it is a Fram filter catalog number

I went to Fram.com, chose product catalog at the top of webpage , and got this webpage:

http://www.power-21.com/FramPower21i/

I put PH3600 in the -Quick Parts Search- box . Note: when I put this number or the motormaster number in the other search box "competitior" it returned no hits.

"Quick Parts Search" returned a really long list and when I scrolled down I found under "Ford", my Taurus. There was no listing for Chevrolet, so I am pretty sure it is for the Taurus.

How do you replace the front emergency brake cable on a Dodge Grand Caravan SE 3.3?

User Avatar

Asked by Wiki User

Here is how to easily on a 2007 grand caravan. I'm assuming you will replace it because it is broken.. meaning the outside end broken as that is weathered and in the inside isn't... Quickly disconnect the outside part of the cable and bring it up through the floor..easy... remove moulding inside near brake pedal. Now the trick nobody wants to tell you is that you need tension on the cable and you need to lock the cable with tension before you remove it... key thing.. leave it in the tension position with screw driver while you get cable fixed or put in a new one. Many people say how do you get the end of the cable off the self adjuster brake pedal unit... books state a lock open part of the brake unit.. try to find it? Too hard... What you do is pull the cable as much as you can with vice grips about 5 or more inches down from the tip. if the cable is broken you can pull it through the outside shield so it is only the inner cable left. Now when you pull it to maximum pressure you then put the screwdriver in horizontally on your side of the brake spring (not where they say there is a lock out thing)... get a smaller flathead in there and feel for it to lock things up. You'll know when it is solid and holds itself. The step next when it is under tension and solid is to push the cable forward and get it out of the unit. You may find a screwdriver to widen the area it comes out of is good.. then later when the new one goes in crimp it back with pliers... Whatever you do make sure that screw driver is in good . I could do that section of the removal now in about 2 mins knowing that the screw driver holds in the right place... When you put the new one in leave the screw driver until the last thing.. it gives you all the roof to connect both sides up... Further to that... it shall be tested long term still but you can youtube cable end repair an do your own lead repair on the existing cable.. since it is a self adjuster the cable length has some play...

How do you replace an electronic control module on a 1995 Mercury Cougar?

User Avatar

Asked by Wiki User

I am not a mechanic by any means, but a nice mechanic at Tires Plus showed me where the Constant Relay Module was yesterday. Of course, that was after they sold me a freon boost and let me drive away without telling me that my air conditioning still did not work. I had to call back the next day to receive an estimate of $340.00 to have a new module installed. From what the mechanic showed me and told me - The module is located on the driver's side, front section of the engine compartment below the air filter. You must unclip and remove the air filter/intake cowling. Look straight down and you should see the little black box or module. You pull out the old one and install the new one, making sure that the pins match. From my reading, you probably need a screwdriver to remove the the screws holding it down. If you are handy with circuits, switches, and soldering, you may be able to repair the module itself, using a relay switch ($4.75) from Radio Shack or just a soldering iron ($ 0.00). Do an Internet search on relay switch, soldering, CCRM, Radio Shack, etc and you should find a detailed explanation of the process. Good luck, CWB

Where is the transmission speed sensor on 1995 Toyota Avalon?

User Avatar

Asked by Wiki User

The Direct Clutch Speed Sensor is on top of the transmission (in front of the driver) and secured by a 12mm bolt to the transmission casing. It looks like a vertical black tube with an arm that extends toward the driver with the bolt at the end. The top of the tube has a black connector plugged onto it with two wires that join a major wiring harness a few inches away.

Why is it when your 2002 Chevy S-10 LS Brake lights stay on after the vehicle and lights are turned off?

User Avatar

Asked by Wiki User

That's because your car is equipped with a light sensor that works in that way; after a few seconds the lights will go off. Any more questions?, please feel free to contact me at alg11@televicable.net.mx

What would be the problem causing a 1994 cutlass sierra s not to start?

User Avatar

Asked by Wiki User

There isn't much information in that question. Is it cranking? If not, it could be battery, battery terminals, starter, keyswitch, neutral safety switch... who knows what else. If it's cranking but not catching, always go back tot he basics; compression, ignition and fuel. If any one of the three isn't there, it won't run. First and easiest, check the ignition. Find a spare sparkplug, pull a single plug wire from the engine, connect the sparkplug to the wire, lay the plug on a solid piece of metal and crank the engine to see if you have a good strong spark. If not, track it down. If you have spark, go on to fuel. Try a little starting fluid to see if you can get it to start briefly. If it starts with starting fluid you probably have a fuel delivery problem. If it won't start with starter fluid run a compression test.

How do you release a parking brake with a broken release handle on a 1993 Chevrolet truck?

User Avatar

Asked by Wiki User

Best ways are if you can see exposed cable underneath the truck, go underneath and yank down on the cable as hard as you can. If the parking brake isn't needed or you just need to free the brake to move the truck and can go get it repaired if necessary, cut the cable back by the brake and the brake will release. Shouldnt cost more that 150 bucks to get a new e-brake installed.

Will a 97 dodge caravan 4 cylinder 3 speed 31TH transmission fit in a 96 Plymouth voyager 6 cylinder 3 speed 31TH transmission?

User Avatar

Asked by Wiki User

Yes gran caravan use 31th or 41te The bell housing on a 3.0L is unique and will not interchange.

Why is your 1996 Dodge Caravan overheating?

User Avatar

Asked by Wiki User

The Mercury Villager and Nissan Quest are basically the same vehicle. The radiator is cooled by an electric fan and thermostat. If either of these are malfuntioning, that could be the cause. Otherwise, all of the normal things such as low coolant, bad water pump, clogged radiator, bad radiator hoses, bad thermostat,and incorrect timing could all cause the engine to overheat.

Where is the inertia switch located in a 1992 mercury tracer?

User Avatar

Asked by Wiki User

According to the 2001 Mercury Cougar Owner Guide :

The fuel pump shut off switch ( inertia switch ) is in the drivers foot well ,

behind the kick panel ( there is an access hole )

How do you fix a 1993 Dodge Caravan V6 3.3 liter that won't start?

User Avatar

Asked by Wiki User

You have to figure out first, is it getting spark? Is it getting fuel? Have you disconnected a spark plug wire and cranked engine? Have you checked fuel pressure? . Start there first and get back. Need more info to help you.

Dodge caravan won't start just clicks when turning key?

User Avatar

Asked by Wiki User

Chrysler vehicles have a clicking sound when the starter is bad. It must be replaced, Sometimes they can be lighty smacked with a blunt object and will work for a while but will still need replaced..

try looking at your battery terminals if they are loose or broken

What is the voltage of a 2001 dodge caravan alternator?

User Avatar

Asked by Wiki User

Most or all automotive alternators output 12+/- Volts DC. The actual output varies slightly depending on the age of the alternator. A new one typically outputs around 14Volts which decreases with age. Once the alternator starts ouputting less than 12Volts, you should consider rebuilding or replacing it, since it won't be able to keep up to the vehicle's electrical demands.

Alternators should be between 13-15 volts. If it only outputs 12 volts, then it is bad....an alternator cannot maintain charge on the battery (12.5 volts ideally) and provide amperage to all of the accessories on the car with only 12 volts output. More importantly, the amperage and diode pattern on your alternator determines good or bad. You cannot properly test an alternator with a multimeter.

How do you replace the timing belt in a 1994 Chevy lumina 3.1L van?

User Avatar

Asked by Wiki User

<< palmboy 051605>>

Well, ...

For a 1994 Lumina APV (3.8L), simply rotate the tensioner using a long adjustable or simlilar wrench (for torque) or tratchet/socket counter-clockwise. The tensioner is pulley-like mechanism between the power steering pump and the water pump. Once rotated, there will be slack in the belt to remove it from the remaining components.

Use the diagram (sticker) inside the hood cabin (near radiator) as a reference for routing the replacement belt. Position belt and rotate tensioner to provide slack for final belt placement (over alternator pulley) and release tensioner.

This is probably a similar procedure for your 1993 APV.

PB

Where are the fuel injectors located?

User Avatar

Asked by Wiki User

If you have a MPFI (multi port fuel injection) the injectors are either on the intake manifold or the cylinder head in either case they are usually close to where the intake manifold and cylinder head meet.There will be a fuel line feeding all injectors and a electrical plug to each one.Since I don't know what vehicle you are referring to,it is possible it has throttle body fuel injection,looks a little like a carburetor and will be on the intake manifold.

What is the motto of Caravan Pictures?

User Avatar

Asked by Wiki User

Caravan Pictures's motto is 'Spell your entertainment'.

Which wires are positive and negative on the rear speakers of a 1995 Dodge Caravan?

User Avatar

Asked by Wiki User

if you are installing a radio i would strongly suggest going to walmart and spending 6 dollars on a wiring harness. Make sure it is the one for your year, make and model of vehicle and also buy an installation kit. you will save yourself alot of time and frustration this way and when you are done, you will have a professional install. the wiring is easy this way as all you do is match up the wires

How do you change an alternator on a 1999 Dodge Grand Caravan SE?

User Avatar

Asked by Wiki User

I have a 1993 dodge grand caravan, and have taken the alternator off of the bracket, but it will not fit down the back of the motorand under the fire wall. I have tried to remove the alternator bracket , but it looks as though it is trapped behind the tensioner pulley. I don't see how to remove the pulley bracket and don't know if this will work at all. What a crazy design! I hope someone out there can help.

Which fuse operates the radio on a 2004 dodge caravan and where's it located?

User Avatar

Asked by Wiki User

if you look under your hood, on the drivers side you should see a black box for fuses it should be right there and labeled.

check out fuse #5. The link below is an excellent diagram of the fuse box for a 2004 Dodge GC. I blew the fuse with a small compressor while inflating tires. My brother in law was researching my prob w/ me & he found a source that tied fuse #14 to the radio as well if #5 doesn't get it.

Why would the speedometer in a 96 Dodge Caravan work but the odometer not and how do you fix it?

User Avatar

Asked by Wiki User

I have the same problem on an '89 Dodge Dynasty. I am told that the odometer and speedometer in my car are driven by separate cables and that I simply need a new cable for my odometer to function properly again. I have not verified this information, but it might get you on track.

Where is the oil pan located in a 2000 dodge caravan?

User Avatar

Asked by Wiki User

It is located in your distributor.

Take off the distributor cap.

Take off the rotor.

You will see it underneath there, its got a magnet piece.

Also, to make things more clear,

It is where the electrical connection plugs into on the side of the distributor.

That is the cam sensor.

Why does your car shake when you turn it off?

User Avatar

Asked by Wiki User

Movements in your car's motor causes your car to move slightly from side to side. When the engine is running, the movements are so fast that the car is balanced - it doesn't have a chance to move to one side before the opposite force moves it back the other way. When you turn the engine off, these forces slow down and as the engine stops running the forces from side to side get slower until they actually move the car for a moment - and it shakes from one side to the other until the engine stops.

Fuse diagram for 1994 Dodge Caravan?

User Avatar

Asked by Wiki User

#1 -25 amp rear wiper & washer, #2 -15 amp radio, radio clock illum, lighter, dome lamp, #3 -empty, #4 -15 amp flash to pass, #5 -25 amp blower motor, #6 - 30 amp circuit breaker power windows, #7 -2 amp anti-lock breaks, #8 -20 amp turn signal flasher, #9 - 10 amp radio, courtesy lights, glove box, cargo, dome lamps, #11 -25 amp headlamp delay module, horns, #13 -20 amp power door locks, #15 -15 amp Instrument Panel lamps, clock, radio / clock illumination, rear lamps, front lamos, #16 - 30 amp circuit breaker powwer seats, trailer tow, #17 -7.5 amp inst. cluster gauges, headlamp delay module, chime module, #18 -25 amp heated rear window, #19 -5 amp instrument panel lamps, #20 -5.5 amp circuit breaker windshield wiper / windshield washer.