There is a spout on the rear close to under the seat. See picture

5 foot X 6 foot

run the twine through the eyelets and through the needles , which are the large arms that rise up . take that twine and tie to the rear of the baler,both of them and run them where the bale forms. next trip the wheel that ties the bale, and turn the baler by hand for one cycle. the twine will be tied now cut the excess twine that u tied to the rear of the baler from the needles and you are ready to bale .

Drain oil

Remove the right hand side round speed control cover

Remove the small roller that the vertical arm acts on, you just spread the fork it sits in

Remove all bolts around the top cover, not the 4 nuts they hold the levers in place

Use a chain block and a lifting plate, which can bolt onto the seat bolts to lift the top cover directly up

Remove the pin holding the pto spline coupling together

Remove the bolts holding the pto cover and pull the pto shaft outwards

This should allow you to unbolt the pump and remove it

Behind front grill in a canister. Simply unscrew the canister and there is a cartridge filter inside. Car Quest carries the replacement filter for around 40 bucks.