Hydraulics
Due to its immense power, hydraulics are used for operating various machinery, vehicles, aircraft, ships and equipment. The data and engineering revolving around hydraulics is so vast, its hard to comprehend.
Total questions 5000
Follow
ID3455765457
added What advantage does oil have over a hydraulic fluid to Hydraulics 27 May 2012 02:47
Snooze2702 [28]
added Explain how a light push applied to the lever of a hydraulic barbershop chair can lift a person in the chair to Hydraulics 26 May 2012 13:15
Snooze2702 [28]
added How can a light push applied to the lever of a hydraulic barbershop chair lift a person in the chair to Hydraulics 26 May 2012 13:14
Ldoctor [0]
made this change to the answer of What would you need to make a hydraulic system 25 May 2012 20:37
Answers
Andrew sheung
Hobofred
Dr Zane Winston Oliver
Clay
Edits
Ldoctor
Keats
Andrew sheung
Drunken Russian Medic
Mannydlr
Organization
Keats
Snooze2702
Angela-Chao
Geedup2011
Questions
Angela-Chaoyes a motor can be used in place of a pump on most applications. the difference between a pump and motor is the intake and...
Popularity: 14 • Tools: Recategorize
hydraulic machines work with help of pressurised liquids where as pneumatic machines work with the help of pressurised gas
Popularity: 14 • Tools: Recategorize
A rotary flow divider is essentially two hydraulic gear motors of equal displacement that are mechanically linked (the output...
Popularity: 14 • Tools: Recategorize
The short answer is yes, if it will do the job required. Why was 32 chosen in the first place? A thicker oil will not flow as...
Popularity: 14 • Tools: Recategorize
Hydraulic fluid could be used in two locations on your 1993 saturn. your brake system is of course Hydraulic, in this case, the...
Popularity: 13 • Tools: Recategorize
Non-dealer $60 per hour
Popularity: 13 • Tools: Recategorize
Yes there is a hydraulic clutch on the miata. Just to the outside of the firewall, near the brake master cylinder is the clutch...
Popularity: 13 • Tools: Recategorize
Liftlocks allow for watercraft to navigate from one elevation to another. The following is my understanding of how they work. ...
Popularity: 13 • Tools: Recategorize
What kind of hydraulics? Transmission, Brakes?
Popularity: 12 • Tools: Recategorize
REGULAR GM ATF FLUID
Popularity: 12 • Tools: Recategorize
This works for any hydraulic system, clutch or brakes. On the slave cylinder is the bleeder screw. Use a piece of tubing that...
Popularity: 12 • Tools: Recategorize
smallest volume over which measurements can be made that will yield a representative of the whole.
Popularity: 12 • Tools: Recategorize
A servomechanism, usually shortened to just servo, is a device used to provide mechanical control at a distance. For example, a...
Popularity: 12 • Tools: Recategorize
Check with the manufacturer. There are website for all major companies and they provide addresses for repair facilities.
Popularity: 12 • Tools: Recategorize
Follow this link (or copy and paste into your browser's address bar): http://www.hyjacks.com/H7.HTM then scroll about halfway...
Popularity: 12 • Tools: Recategorize
yes it is with the slave cylinder being inside the bee housing. the clutch master cylinder reservior is to the right facing the...
Popularity: 12 • Tools: Recategorize
Power steering fluid is a hydraulic fluid and is engineered to do a specific job - it should not be mixed with anything.General...
Popularity: 12 • Tools: Recategorize
Hydraulic Conductivity: Hydraulic conductivity refers to the ability of the aquifer material to transmit water, which in turn,...
Popularity: 11 • Tools: Recategorize
Among other reasons, oil is a natural lubricant, it doesn't evaporate readily, and it doesn't support corrosion. Oil has a much...
Popularity: 11 • Tools: Recategorize
Hydraulic motors will run at a faster speed and pressure will build up rapidly possibly in excess of the systems capacity....
Popularity: 11 • Tools: Recategorize
Start dictating form the source current thor' the Load connected.
Popularity: 11 • Tools: Recategorize
by using a non-compressible fluid, it acts like a solid push-rod.
Popularity: 11 • Tools: Recategorize
Because liquids can't be compressed - only pressurized. With a liquid, whatever force you put in at one end is what you get out...
Popularity: 11 • Tools: Recategorize
They direct the energy of the fluid's pressure to utilize that energy. This energy can be used to do anything from operating an...
Popularity: 11 • Tools: Recategorize
no
Popularity: 10 • Tools: Recategorize
The flow of oil in an hydraulic system can be compaired to any water system; in both systems you will find the tank (place where...
Popularity: 10 • Tools: Recategorize
1. car fuel pump 2. excavator 3. human heart
Popularity: 10 • Tools: Recategorize
It means how much oil is needed to make the motor turn one full revolution. If you have a 32 Cubic Inch Hydraulic Motor, you...
Popularity: 10 • Tools: Recategorize
The orifice plate can easily be changed to accomodate widely different flow rates, whereas the throat diameter of a venturi is...
Popularity: 10 • Tools: Recategorize
If Q = flow rate (m3s-1)v = velocity (ms-1)A = area (m2)and P = pressure (Nm-2)F = force (N)Q= v x Aand P = F X A-1therefore the...
Popularity: 10 • Tools: Recategorize
The EPA limits gas station pumps to no more than 10 gpm. The average gas station pump is between 5 and 10 gpm.
Popularity: 9 • Tools: Recategorize
It works jusy like your brakes. pump thgem then hold release the bleeder then tighten back up then pump 3x's and hold, crack the...
Popularity: 9 • Tools: Recategorize
easy: Both use pressure now hydrolics used liquids (liquids cannot be compressed) to exhert pressure pneumatics uses gasses...
Popularity: 9 • Tools: Recategorize
circulatory system and respiratory system are 2 examples
Popularity: 9 • Tools: Recategorize
First off, working with hydraulics can be extremely dangerous. With pressures up to 2500 PSI or more, if something is connected...
Popularity: 9 • Tools: Recategorize
Popularity: 8 • Tools: Recategorize • Needs Answer
http://www.fdpp.com/FAQ.htm "Actually there isn't any since a strainer is, in reality, a coarse filter. The question is then one...
Popularity: 8 • Tools: Recategorize
The one main characteristic that changes downstream is the gradient decreases. The type of sediment found in this area of the...
Popularity: 8 • Tools: Recategorize
Yes, all clutches on KA's are hydraulic.
Popularity: 8 • Tools: Recategorize
There is no replacement for this filter.
Popularity: 8 • Tools: Recategorize
it is a proccess of cdleaning wasste from a compound
Popularity: 8 • Tools: Recategorize
If the hoses ("tubes") expand, the pressure available at the working device will be lower, reducing the force available. Also, if...
Popularity: 8 • Tools: Recategorize
Just behind the PTO-lever. You remove the cover and then its possible, with some patience, to shift it.
Popularity: 8 • Tools: Recategorize
galvanised material may flake off and set into moving part
Popularity: 8 • Tools: Recategorize
10w30 or 15w40
Popularity: 8 • Tools: Recategorize
Apple Truck and Trailer of Auburn Massachusetts is one dealership you could try.
Popularity: 8 • Tools: Recategorize
If it's not a lot there shouldn't be any problem. The two are not going to mix, the oil isn't going to affect anything in the...
Popularity: 7 • Tools: Recategorize
Depends how good are the hydraulics.
Popularity: 7 • Tools: Recategorize
The book says the intire hydraulic system holds 36 gallons and the tank holds 28 gallons. This is from the manual of a 1998 555E...
Popularity: 7 • Tools: Recategorize
About 29-29 inches of vacuum.
Popularity: 7 • Tools: Recategorize
When you step on the brake pedal, a force is applied directly to a piston of area 'a'. The hydraulic fluid thus pressurized is...
Popularity: 7 • Tools: Recategorize
On the left side of the motor. It has an about 1" blue tube going to it.
Popularity: 7 • Tools: Recategorize
Displacement is the measure of how much fluid it takes to turn the hydraulic motor shaft per revolution. It is typically...
Popularity: 7 • Tools: Recategorize
Niether. Although it is possible to inflate an airbag with pneumatics, most car airbags are actually inflated by an explosive...
Popularity: 7 • Tools: Recategorize
Assume a small piston (one square inch area) applies a weight of 1 lbs. to a confined hydraulic fluid. That provides a pressure...
Popularity: 6 • Tools: Recategorize
Some can - because they are designed to be able to spread their weight (displacement) over a wide enough area that can be...
Popularity: 6 • Tools: Recategorize
Hydraulic lifts utilize a hydraulic piston or ram, typically oil filled, to supply the lifting force for raising or lowering an...
Popularity: 6 • Tools: Recategorize
Hydraulics is the term we apply to engineering compressed liquids. The industry frequently applies the term fluid power to...
Popularity: 6 • Tools: Recategorize
Gas shocks are considered better and are usually more expensive. They use pressurized nitrogen to absorb shock, as opposed to...
Popularity: 6 • Tools: Recategorize
Pneumatic system is operated by compressed air while hydraulic system is operated with pressurised hydraulic oil or any type...
Popularity: 6 • Tools: Recategorize
Seminar Topic in Structural Engineering are as under. 1. Fibre Reinforced Cements and Concretes: Recent Developments. 2....
Popularity: 6 • Tools: Recategorize
Hydraulic action is a form of mechanical weathering caused by the force of moving water currents rushing into a crack in the...
Popularity: 6 • Tools: Recategorize
calculate the no of pipes in the circuit & then work out the volume based on the area.
Popularity: 6 • Tools: Recategorize
Force = pressure X area.
Popularity: 6 • Tools: Recategorize
We use it for plastic molds :) e.g. plastic cups, toys or things made of plastic.
Popularity: 6 • Tools: Recategorize
Only use the type of hydraulic fluid recommended by the equipment manufacturer. Hydraulic oil serves several purposes in a...
Popularity: 6 • Tools: Recategorize
There is no adjustment on a master/slave hydraulic clutch system. It is self adjusting every time you release the pedal, the...
Popularity: 5 • Tools: Recategorize
There isn't one. The clutch is cable-actuated.
Popularity: 5 • Tools: Recategorize
To stop the car every time you use the brakes.
Popularity: 5 • Tools: Recategorize
cleanroom software engineering implements waterfall model.
Popularity: 5 • Tools: Recategorize
Wikipedia has a really good article on hydraulics ; see related link below .
Popularity: 5 • Tools: Recategorize
Clear tube right below where the filler cap is located
Popularity: 5 • Tools: Recategorize
Look for a hinged panel between the loader uprights. That is where the hydraulic reservoir fill port is located. Lift the hood...
Popularity: 5 • Tools: Recategorize
The rubber gasket failure.
Popularity: 4 • Tools: Recategorize
The pump is located in the trunk behind the back seat. You will need to place some rags to collect the hydraulic fluid....
Popularity: 4 • Tools: Recategorize
Ones name is pneumatic and the other is hydraulic! (That doesn't really help)
Popularity: 4 • Tools: Recategorize
PRINCIPLES OF HYDRAULIC PRESSURE A Frenchman named Pascal discovered that a pressure applied to any part of a confined fluid...
Popularity: 4 • Tools: Recategorize
mostly oilAll our the more modern cranes in our fleet use ISO 68 hydraulic fluid. In many cases, the manual calls out for ISO 32,...
Popularity: 4 • Tools: Recategorize
ISO Grade 68 flashpoint is 430 degrees F
Popularity: 4 • Tools: Recategorize
well if you drive that's one of the reasons why your able to stop ( your brakes are hydraulic ).....same for that effortless...
Popularity: 4 • Tools: Recategorize
http://www.mass.gov/Eeops/docs/dps/appl/appl_hoisting.pdf Apply for a hoisting/hydraulic license through the Mass department of...
Popularity: 4 • Tools: Recategorize
answervery carefullanswerOK HYDRAULIC ON CARS ARE ALL DA SAME,THE MAIN KEY FIGURE OUT A WAY THOSE FLUID PIPE LINES ON DA SLAVE...
Popularity: 4 • Tools: Recategorize
THE FUEL CONSUMPTION OF DIESEL GENERATOR DEPENDS UPON LOAD.A 500 KVA D.G CONSUMES MIN.60 LITRES/HOUT AND MAX. 70 LITRES/HOUR
Popularity: 4 • Tools: Recategorize
Only the sweep is linear cylinder.Motor rotates the hydraulic oil pressure.
Popularity: 4 • Tools: Recategorize
There is no dipstick or level plug on these tractors. The way to check it is to measure 18 centimeter from top of filler hole...
Popularity: 4 • Tools: Recategorize
YCMOU B.Tech. (Electronics Engineering) and YCMOU B.Tech. (Mechanical Engineering) ==
Popularity: 4 • Tools: Recategorize
There is distillation, evaporation, chromatography, using of separating funnel, centrifuging, desalination, fractional...
Popularity: 4 • Tools: Recategorize
One definition is that it's a region of the Earth's atmosphere where air pressure is unusually low, like a hurricane or a...
Popularity: 4 • Tools: Recategorize
Where can I go to get a hydraulic license
Popularity: 4 • Tools: Recategorize
The hydraulic lift was invented by Leon Edoux.
Popularity: 4 • Tools: Recategorize
what is the Accuracy and limitations of the Venturi meter.
Popularity: 4 • Tools: Recategorize
it is the property of the liquids. all the liquids are incompressible.this is because the change in volume due to pressure is...
Popularity: 4 • Tools: Recategorize
