I looked this up in my Manual for my 99 GMC Yukon, and it mentions adjusting the Shock Sensor. The manual states "The sensor can be adjusted if more or less sensitivity is desired. If sensitivity is increased too much, it may give false alarms caused by gusts of wind or other natural events that may shake the vehicle. The adjustment for the shock sensor sensitivity can be accessed through a hole in the forward wall of the main bin of the center floor console. Using a small flat-tipped screwdriver, turn the adjuster clockwise to increase sensitivity, and turn counterclockwise to decrease sensitivity." On my Yukon, the hole in the center console is right next to the forward end of the multiple CD changer. I used a mirror and flashlight and made a note of what sensitivity the Shock Sensor was currently set, so I knew how much I will change the sensitivity. On my Yukon, I turned the sensitivity a little counterclockwise (decrease sensitivity) and drove and used the Yukon normally to see if the sensitivity was what I wanted, and then turned it a little more if needed. Then it will be set and forget, unless you park in a unfamiliar area, then you know how to turn up sensitivity if needed.
The new chipless key, or unmatched key will need to be reprogrammed into the cars computer.
I have a Scytek alarm in want to insall on my 99 Yukon without instruction
The easiest way to disable the 1998 Chevy Lumina factory alarm is to remove the factory alarm fuse. The factory alarm fuse can be found in the fuse box.
The factory alarm can not be unhooked or disabled.The factory alarm can not be unhooked or disabled.
The easiest way to disable your 1993 Buick factory alarm is to remove the alarm fuse. The alarm fuse can be found in the fuse box.
How do you disable the alarm system on a 1998 yukok
try the key if it is a factory alarm try the key if it is a factory alarm
The factory alarm is reset by unlocking the doors with a key or the remote.The factory alarm is reset by unlocking the doors with a key or the remote.
The factory alarm is part of the body and engine computers.
how to disarm the factory alarm on a 2000 lincoln navigator
drive it off a cliff, because GM won't help you. Make sure you jump out of the POS over-priced SUV BEFORE it goes off the cliff. Wait for explosion (hopefully) when it hits the bottom of the gorge - alarm reset - permanently
The easiest way to disable your Kia factory alarm system is to remove the alarm fuse. The alarm fuse can be found in the fuse box.