in wire cut, a wire is passed through a metal or is placed next to it. the wire works as one of the electrodes while the work piece would be the other one; using andielectric liquid to isolate the wire from the work piece. the electricity is conducted in the wire. as the wire gets closer to the work piece the electricity (electrons) tend to jump from the wire to the work piece in order to create a complete electrical circuit that's when a spark is formed. the dielectric helps us by isolating the wire from the work piece as long as it can, so we can have enough difference in potential between two electrodes before the spark is formed, it works like capacitor stopping the current from going through it until it collapses at a potential and enough current passes through at once. A collateral effect of this passage of current is that material is removed from both the electrodes.
With an insulated handle wire cutter.
Black is hot and white is neutral. If you are switching something you switch the black, so that is what you would cut.
No. Get is connected as soon as possible for safety's sake.
-wire can be taken straight to the pin and not positioned in plastic 'valley' (usually mistake made in earth wire) -wire cut when outer cable is removed -cable grip clamped onto three wires instead of cable -loose copper wires visible.
If the exposed wire grounds out and a great amount of heat is produced then yes a fire could start under this condition. Remember overhead transmission wires are exposed wires but are well insulated from ground so as not to have the above scenario happen.
EDM works by creating thousands of sparks. The sparks melt or vaporize the material instead of cutting it. This process works best on non-ferrous metals, such as steel.
an edm is a electrode discharge machine. it uses electicity through an electrode to precision cut metal submerged in oil.
I can think of two different things this might be: 1. Dies can be used to make wire. The wire is pulled through a smaller hole to make a thinner wire. The tool with the small hole would be a die. 2. You might be referring to wire EDM (Electrical Discharge Machining). This is a way of cutting metal with electricity. It is often used in the fabrication of dies because it can cut through the hardest metal - metal that is too hard to cut with normal cutting tools.
Cut the Wire was created in 1987.
You Should Cut The Yellow Wire! : D
you can cut any wire you choose to cut. i, however, would not cut it.
Machine tool is a term used to describe a variety of metal cutting and forming machines. Some of those machines are as follows, lathes (cut metal by "turning"), milling machines, brake press and shear, drill press, EDM, water cutting machines.
You cut carefully so that the wire does not touch the middle of the clay.
With a pair of wire snips.
Originally in WW1 - To break through the barbed wire obstacles and the enemy trenches w/o being cut down by machine gun fire.
Cut the blue wire that goes into the actual motor
Cut all of the wires