answersLogoWhite

0


Best Answer

Changing a rubber seal on the inner side of a washing machine door is not too difficult. You must follow instructions carefully. Open the door and find the clamp that is holding the seal in place, this can usually be removed with a flat screwdriver. Once that is removed there may be a smaller one that can be taken off the same way, remove this also. Remove the band with a little tension using both hands.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How can one replace a rubber seal on a washing machine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you clean mold off the rubber seal on a high efficiency washing machine?

To clean mold off the rubber seal, put 1/2 a tablespoon of bleach in the machine and run it empty, or put 1/4 a teaspoon in 1 cup of water and let it sit for 20 minutes.


Why does washing machine leak from the bottom?

The most likely cause of a washing machine leak is a small hole in the rubber door seal which can be easily replaced.As a temporary measure the seal can be loosened and twisted 180degrees until the top is at the bottom. Probably a bad tub bearing. Live with it, or get a new machine. +++ It won't be the bearing because the shaft is outside of the drum, but it could be a leak on one of the pipe joints, or (as happened on mine) on the pump, which does use a shaft running through a bush and seal from the inside to the outside of the pump body.


How do you replace the rubber seal around windows?

you rip off or scrape the old stuff apply adhesive where the old stuff was and then apply the new rubber seal


Should you replace a rubber seal on a front windshield when changing the windscreen?

Yes


Where can you buy the rubber seal for the sunroof on a 1974 Super Beetle?

Machine 7 or Just aircooled


How to fix a Grand prix sunroof leak?

Replace the rubber seal. You could seal with silicone but you would be unable to open it again.


Whats the name of the Rubber around the boiler outlet on espresso machine?

I reccon ur talking about the group seal or cup washer. (if you are talking about the rubber ring that seals the group handle to the machine)


Is there a way to replace the shiftrod seal in a 1990 Ford Probe with a 5-speed transmission without pulling out the entire transmission?

i think you can replace the seal by removing the rubber shift boot


Is the rear main seal rope or rubber seal?

Rubber.


How do you replace 98 Bonneville thermostat?

removed thermostat on 98 Bonneville and also removed rubber seal -- cannot get the old seal back into the housing.... help


How do you remove and replace the windscreen on an peugeot 205 1.8cc diesel?

Cut the rubber seal and gently push the windscreen out.


How do you fix a belvedere 622 faucet from leaking?

As in any faucet, you take it apart and replace the cartridge or the rubber seal.