under the car,behind spare tire,is the wiring harness with access plug for dodge trailer harness (optional) my came with 2012 journey
The starter on a 1998 GMC Sonoma is replaced by disconnecting the battery, removing the outer cover, and unbolting it from the engine. The wiring harness can then be disconnected, the starter removed, and a new one put in place.
The wiring harness for the radio in a 1991 GMC Pickup is going to be behind the radio. The wiring harness is plugged into the back of the radio. The fuse for the radio is in the fuse box located on the driver's side below the dashboard.
it's at the rear behind the left side cover. once the cover is pull you should see a plug in. You may have to go to the dealer to get the proper wiring harness.
If all you want to do is change a bulb, you pull the license plate off to gain access to the wiring harness. After you twist the harness counter clockwise to loosen the harness, let it drop down and access it to change the bulb from underneath the car.
Removal of the cooling fan on a 2002 GMC Sonoma 4.3l begins with disconnecting the battery, removing the wiring harness to the fan, and taking off the protective shroud. The fan can then be unbolted from the frame and removed.
It Is Behind The Glove Compartment...It Should Have A Blue Wiring Harness Conector.
The wiring harness to the Powertrain Control Module ( PCM ) can be seen from the engine compartment . Look at the firewall on the passenger side and you will see a wiring harness that is bolted to one end of the PCM , the rest of the PCM is " hidden " behind the glove compartment
You need to remove the dash panel. It will allow you to get access to many connectors and it will be easier to remove the harness.
There is a wiring harness most everywhere you look on that and any vehicle. Be more specific.
Remove the rock guard behind the bumper to allow access to the back of the lamp in the bumper. Unhook the wiring harness from the lamp, and it will be a quarter turn to remove. Common bulb, can purchase anywhere.
The wiring harness to the Powertrain Control Module ( PCM ) can be seen from the engine compartment . Look at the firewall on the passenger side and you will see a wiring harness that is bolted to one end of the PCM , the rest of the PCM is " hidden " behind the glove compartment