The valve clearance is set by grinding the faces if there is too much clearance or grinding the tip of the stem if there is too little.
If it is a OHV engine you can easily adjust the valves. Try going to the link below for a video that shows how to adjust the valves.
adjust valves at rocker nuts until all noise (clatter goes away then turn each adjuster 1/4 turn at a time .let the engin recover as it will run a bit rough . then turn again unti the adjuster has turned a full 360 degrees or one turn
add 4 quarts, start, check and adjust level.
YES !!! it is a close tolerance engin . if the timing belt snaps in drive mode the valves will bend .
It requires an engine scanner to set the timing on that year engine.
Camshaft will be broken and inlet/outlet valves will be damaged. engin must be rebuilt or replaced.
Engin Akyurek is a/an Actor
hallo engin
Engin İpekoğlu was born in 1961.
Engin Ardıç was born in 1952.
Kenan Engin was born in 1974.
Atilla Engin was born in 1946.
The population of Engin Limited is 80.