 |
How do you bleed the clutch on a 1982 Toyota Pickup 2WD? |
[Edit] |
First you will need a helper. Second a small 1/8 inch ID Clear rubber hose about 3 ft long, a bottle to catch the brake fluid and the correct size box end wrench (so you don't screw up the bleeder value). Next locate the bleeder value on the slave cylinder attach your clear hose. Have your helper "pump" the clutch pedal 4 to 5 times and hold it down then you turn the wrench to release the pressure. Then tighten it and have your helper pump the pedal again and repeat till you feel the air is removed from the line.
Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information.
First answer by Oilman. Last edit by Oilman. Contributor trust: 430 [recommend contributor]. Question popularity: 23 [recommend question]
Answers.com > Wiki Answers > Categories > Cars and Vehicles > Asian Cars > Toyota > How do you bleed the clutch on a 1982 Toyota Pickup 2WD?
Our contributors said this page should be displayed for the questions below. (Where do these come from ) |
| If any of these are not a genuine rephrasing of the question, please help out and edit these alternates. |
