To find the velocity ratio of a pulley, you must first find the effort and load distances. then you divide the two and there you have you VR (velocity ratio).
Friction on pulley can be measured by compare theorhetical acceleration from force act and measure the actual acceleration to find the force done by friction.
Friction= (coefficient of friction)(normal reaction) If you don't have the friction or the coefficient of it I'm sure you must have been given something else. Could you add the exact question to the discussion ?
A fixed pulley is the only pulley that when used individually, uses more effort than the load to lift the load from the ground. The fixed pulley when attached to an unmovable object e.g. a ceiling or wall, acts as a first class lever with the fulcrum being located at the axis but with a minor change, the bar becomes a rope. The advantage of the fixed pulley is that you do not have to pull or push the pulley up and down. The disadvantage is that you have to apply more effort than the load
A vacuum will reduce the air resistance of the rotating pulleys and the movement of the belts. The advantages will however be minimal and hard to measure.Friction is required for the belts to move and be driven by the pulleys. A vacuum will not affect the contact between the belt and pulley.
You need to know the coefficient of static friction and the coefficient of moving friction for both objects. The solution involves solving a differential equation so the math is non-trivial.
by experiment. attach a pulley to the edge of a table. attach a known weight to a string through the pulley to another known weight on the table-top. put the particular surface who's coefficient of friction you wish to measure between the table top and the second known weight set on the table top. allow the first know weight to fall. measure its rate of descent. compare its rate of descent with that of the free fall acceleration of gravity for your particular latitude. you now have all the data you need to figure out the coefficient of kinetic friction. can you do that yourself or do you need to know more?
A tyre has more friction than a pulley.
no
It wastes energy. However, SOME friction is also needed, or the pulley would just slip.
sliding
friction hitch
50*
Friction of the pulley
calculate speed drive pulley.
Some of the input force is lost due to friction. If you are using a pulley system then there is friction between the rope and the pulley and there is also friction within the ball bearings of the pulley itself. If you are using an inclined plane there is friction between the plane and the object traveling upon it. In a friction-less world the input is equal to the output.
in the wheel because the treads on the wheel rub against the ground,causing friction
in inches
The mechanical advantage of the pulley system is the inertia and friction of the unbalanced and balanced forces acting on the mechanical advantage which is part of the pulley system....