cps is easy to change
find where it is, usually on front of block.unplug wires,remove blot ,pull out cps,install new cps,replace bolt,attach wires.u are good to go
Pin 1 is +5V, pin 2 is Ground and pin 3 is the signal. Use analog voltimeter in pin 2 and 3. Crank the engine: the pointer of the voltimeter shoud oscilate in range 0V to 5V.
depending on the engine and year it is located under the distributor cap and is plugged into a small harness. remove it carefully . the new one will only go in one way so that part is simple. hope...
Before you change the sensor which is down on the front of the engine you need to see if the magnet is still in place inside the timing chain cover.
On our 2000 ford escort zx2 the camshaft position...