Change how? Move the location, you bust out the concrete and move it. Replace or repair the flange that the toilet hooks to. Cut the existing flange off flush with the floor and install a new repair flange. They can be brass or steel. You can use a PVC one that fits in the drain and seal it with a wax ring under it and screw it to the floor. If you are working with cast iron flange and the slots where the bolts are supposed to go is broken out, they make a repair piece for this. It is a 3/4 inch wide by 3-4 inch long crescent shape piece that slides under the flange and the bolt that holds the toilet fits into it. You may have to chip out a little concrete along the edge to get these under the flange.
Concrete slab must be cut from existing location to new location, and then new drain must be plumbed back to existing drain pipe location.
Supended slab are slab not sit on the ground directlySuspended slab is a slab supported by beams.
Slab-O-Concrete was created in 1994.
No. Concrete won't bond to concrete. It will end up cracking.
Also reffered to as 'slab footing' and it consists of concrete footing beams integrated into the concrete floor slab.
no matter how big the concrete slab is, it will never float
What are Advantage pre cast concrete slab than insitu concrete?
The sewers which are under the concrete slab
what is a ytransfer slab
A concrete slab's thickness can vary greatly depending on the application. Typically, a concrete slab varies between 500mm to thousands of millimeters.
The bathtub trap for a tub located directly on a slab foundation is in the soil under the concrete slab. The builder should have left a small opening in the foundation around drain and trap so that it may be serviced in the future. WIth some excavation you should find the trap about eight inches below the slab surface probably in the direction of a wall where the drain vent stack will rise up through the foundation as well.
Concrete is man-made.
Pouring a concrete slab is the pouring of a fresh unset concrete mix into a prepared area, where it is finished by floating etc to give the required surface, and it sets to form a slab.