Answers.com > Wiki Answers > Categories > Cars & Vehicles > Asian Cars > Mazda > Mazda 626 > How do you change the engine thermostat in a 1996 Mazda 626?

How do you change the engine thermostat in a 1996 Mazda 626?

In: Mazda 626, Mazda Protege [Edit categories]

Answer:

Answer

It is located at the engine at the upper rad hose, When you replace it, make sure the spring goes toward the engine.

First answer by ID0000000000. Last edit by anonymous. Question popularity: 58 [recommend question].

[report abuse]

How do you change the thermostat on a 1993 Mazda 626?
you have to remove the lower radiator hose and the thermostat is located between the radiator hose and engine block. There are two screws holding a mounting bracket over top of it to hold it in...
Where is the thermostat located on a 1996 Mazda 626 2.5 liter engine?
on my 1997 Mazda 626, it's located on the left hand side bottom of the engine where the bottom radiator hose goes to the engine. hope this helps you.
Where is the fuel filter on a 1996 Mazda 626 2.5 engine?
Remove the air filter box, easier to get to. Also under drivers side removing the wheel and the under splash guard will open it up and u can see it. Small hands can be useful, kinda...
How long does it take to change the thermostat on a 1991 Mazda 626?
i would say 30 - 45 minutes to leave a good amount of time. maybe 1 hr if you have problems
How do you change the thermostat on a 99 Mazda 626 v6?
Service and Repair THERMOSTAT REMOVAL/INSTALLATION Disconnect the negative battery cable. Remove the ignition coil (KL). Drain the engine coolant. Remove in the order indicated in the table....