answersLogoWhite

0


Best Answer

If you are changing the switch because you have only high speed or not all speeds are working or none are working, rarely is the speed control switch the problem. The vast majority of the time it is a defective Blower Motor Resistor Pack. Just wanted to point this out. Changing the switch just basically means gaining access to the switch. I have not changed one on an Expedition, so I can offer no help there, is that indeed is the problem.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the fan control switch on the dash in a 1998 Ford Expedition?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change gear oil in a 1998 expedition?

How do you change gear oil in a 1998 expedition?"


Where is the headlight relay in a 1998 Ford Expedition?

The 1998 Ford Expedition headlight relay switch is located in the fuse box. The fuse box can be found in the engine compartment. The headlight relay switch will be in the third column.


Can you put a new ignition switch and door locks on your 1998 expedition?

Yes


Where is the oil pressure switch located on a 1998 5.4 ford expedition?

any pictures


Where is the fuel pump reset button on a 1998 Ford Expedition?

According to the 1998 Ford Expedition Owner Guide : The fuel pump shut off switch ( inertia switch ) is located in the front passenger foot well , behind the kick panel * the reset button is on top of the switch


How many quarts of oil go into a 1998 expedition?

( 6 quarts ) with engine oil filter change ( according to the 1998 Ford Expedition Owner Guide )


Where is fuel pump reset switch on 1998 expedition?

Check your Owner's Manual - you'll find directions in there.


Electronic control module replacement on 1998 ford expedition?

my directional lights and speedometer do not work could this be control mudule?


Where is speed sensor 3 on a 1998 Ford Expedition?

where is speed sensor location 98 ford expedition 4.6 engine nocruise control


1998 ford expedition How do you get the light sensor on the back hatch to disengage?

There is a switch on the light it seft. Off/On/Auto.


How do you replace a blower motor resistor and switch on a 1998 Ford Expedition Eddie Bauer model?

on the passenger side floorboard you will see the black plastic duct work for the heater. you will also see two screws right about the center of it. this is where the resitors are for the speed control of your fan. it takes about ten minutes to change.


What is p1506 code on a 1998 Ford Expedition?

iac valve...idle air control valve