The shifter lights in the 1999 Grand Cherokee is not a light bulb, but rather a thin EL panel.
There are two parts to it, a voltage resistor, and the EL panel itself.
You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.
There are a total of 6 flat screws, and 3 self tapping screws you have removed.
Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.
Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attached to the resistor by two clips.
Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.
Re-install everything in the opposite order.
center console
You do not reset it, it is a fault code. It is not a routine maintenance indicator. Fix the problem and the light will go out.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
CHECK YOUR SPEEDS SENSORS, FIRST THEN MODULES AND WIRING
Just replaced the headlight bulbs in a 98 Grand Cherokee that had the same problem. It had the wrong bulbs in it. It had 9007's in it. Calls for 9004's.
The check engine light on a 2005 Jeep Grand Cherokee looks like this... Here is a link Check Engine Light It looks like a little yellow engine.
You do not reset it, it is a fault code. It is not a routine maintenance indicator. Fix the problem and the light will go out.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
CHECK YOUR SPEEDS SENSORS, FIRST THEN MODULES AND WIRING
That is the check engine light.
Check engine light is reset with a scan tool.Oil change due is reset by pressing "step" until "0 miles to service" is displayed. Then press and hold "reset" until it resets.
Time for an oil change.
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
does a 2008 grand prix have a shifter indicator light on the consule
The light comes on when the computer detects an electrical failure. Have the system diagnosed by a trained technician. The airbag system is not for the diy'r.
How do you install passenger tail light kit for a 2004 grand cherokee?
Change your fuel pump unit(its in the tank).
Yes.