 |
How do you change the serpentine belt on a 1997 Chrysler Sebring?In: Chrysler Sebring |
[Edit] |
Answer for 2.5 v6
on the 1997 2.5L V6 models there is a tensioner pully that is held on w/a bolt on the front of the pulley and adjusted with a bolt on the mount that is to the left of the pulley. be sure you dont have the spring loaded autotensioner because some models on the 1997 line had them. first you have to loosen the bolt holding the tensioner on. then the other bolt on the side of the pulley has to be loosened to relieve the tension on the belt. then just take the belt off and replace with a new one with it going on the right side of the alternator and the compressor pulleys the left side of of the tensioner pulley motor crankshaft pulley. when you start to tighten the belt you have to tighten the bolt that holds the pulley on till it holds it straight but not tight. then you tighten the adjuster bolt until the belt only flexes less than an inch in the area between the alternator and the crankshaft pulley. tighten the hold down bolt and start. listen for slippage when your transmission shifts when you are dogging the car out. if you hear a loud squealch when it shifts then the belt isnt tight enough.
on the 2.5L v6 model there is also a v-belt for the power steering pump which requires the removal of the serpentine belt for replacement.
First answer by ID1197815849. Last edit by ID1197815849. Question popularity: 87 [recommend question]
Answers.com > Wiki Answers > Categories > Cars and Vehicles > American Cars > Chrysler > Chrysler Sebring > How do you change the serpentine belt on a 1997 Chrysler Sebring?
Our contributors said this page should be displayed for the questions below. (Where do these come from ) |
| If any of these are not a genuine rephrasing of the question, please help out and edit these alternates. |
