Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Chevrolet > Chevy Trucks and SUVs > Chevy Silverado > How do you change the wheel bearings on a 2005 Chevy 4 wheel drive pickup?

How do you change the wheel bearings on a 2005 Chevy 4 wheel drive pickup?

In: Chevy Silverado, Chevy 350 [Edit categories]

Answer:

i dunno. =P
if you are reffering to the front bearings you have to buy complete hub assy.

Contributor:

Jeff

First answer by TheLeafFromHell. Last edit by Jeff Munion. Contributor trust: 0 [recommend contributor ]. Question popularity: 1 [recommend question].

[report abuse]

Can you answer these Chevy Silverado questions?

	How do you remove blower motor resistor?	Answer it!
	Why would it turn Any suggestions?	Answer it!
	Are audio nirvana speakers any good for cars?	Answer it!
	How To Install Replace Broken Hood Latch Chevy?	Answer it!
	How do you replace rear brake line?	Answer it!

Can you change a 2 wheel drive to a 4 wheel drive?
It Depends on what type of vehicle you are working with. Some older chevrolets use the same frames and it could be done. The Ford series it is not recommended because the frames on 2wd are not near...
How do you put 2005 Chevy trailblazer in 4 wheel drive?
It is best for the vehicle if you are at a complete stop, put the trailblazer in neutrail, turn the selection knob to your right to whichever setting you would like, wait for it to engage, then put...
How to change a Chevy blazer 4 wheel drive actuator?
On the front differental there will be a tube looking thing about 6 inches or so long sticking out of it. At the end there will be be a spot to stick a wrench on, that's the actuator, just take a...
How do you change the wheel bearings on a 1993 1500 Chevy suburban 2 wheel drive?
u first shabbily ding dong yes that is u change it
How do you change a wheel bearing on a 2000 dodge 4 wheel drive ram 2500?
The bearing comes as a complete hub assembly. Remove wheel. Remove brake caliper and bracket (together) by taking out the two 12 point 16mm bolts on the upper and lower ends of the caliper bracket....