Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Chevrolet > Chevy 350 > How do you change to non-computer controlled distributor on a 350 Chevy engine?

How do you change to non-computer controlled distributor on a 350 Chevy engine?

In: Chevy 350 [Edit categories]

Answer:

Answer

well if you plan on doing that to a stock motor.. I wouldn't do it.. cause the computer would be sending flase information all over the place.. Bad Idea.. But if your putting a different motor in.. Just cut the wires and install your new distribtor.. I totally wiped out all the computer stuff in my car.. cut all wires.. and used old school distributor.. it was very simple

First answer by ID2895939934. Last edit by ID2895939934. Question popularity: 9 [recommend question].

[report abuse]

Can you answer these Chevy 350 questions?

	What is gearing up?	Answer it!
	What causes the headers to get hot and its not running lean?	Answer it!
	What does the stamped number MJ25800 on your Chevy small block designate?	Answer it!
	What does MJ25800 stamped on your Chevy engine mean?	Answer it!
	What is the bolting torque sequence for a Chevy small block intake manifold?	Answer it!

Relevant answers:

Do you have to change the computer when you change the engine?
not at all
Do you need to change the distributor on a new 350 crate engine to install it in a 57 Chevy?
i have a gm goodwrench 350 with a summit hei distributor in my 58 Chevy truckits about 1/2 inch from my firewallso... little room to spare but yes it worked
How can you tell a Chevy 350 engine from a Pontiac 350 engine?
On a small block Chevy the distributor goes through a hole in the intake manifold. On a Pontiac the distributor goes behind the intake manifold.
How do you change the fan belts on a Chevy 350 engine?
Depends if it has a tensioner, or the older type manual adjustment. With a tensioner, put the correct socket on the pulley and depress it by hand until you get the belt changed. the manual style,...
How do you align the distributor shaft to tdc in a 350 Chevy engine?
Turn engine over using center bolt on harmonic balancer or u can bump the starter. Take number 1 cylinder spark plug out and then u stick screw driver in plughole untilthe piston comes to the...