Most Tiburon and other sport car sites should have specific headlight cleaningdetails, but if you want to clean the inside of the lens, you'll need to remove it and either put it in the oven, or apply a heat gun to the seal. Once opened, you can clean it with a rag and some plastic polish for lenses, and then re-seal it with a new tube of weatherproof sealant. You'll need to clamp it or hold it together for some time to insure proper seal.
you need to pull the plastic off on the inside of the car to access it.
The blower motor on a Hyundai Tiburon is located inside the heating and air conditioning duct. Its job is to circulate the air in the car.
The headlight on your 2008 Hyundai can be removed by removing the headlight retaining bolts from the inside of the engine compartment. Remove the wiring harness and replace with a new headlight.
Steel on the inside, a plastic cover on the outside.
According to the 3 different Hyundai dealerships there is not a turn signal relay on a 2003 tiburon. But it is actually located inside the BCM, if you can trust your self with opening the bcm you can change it yourself. Also if you call the dealer they will tell you that the only solution is to replace the BCM but they are full of it, they say that because it a new unit cost $1100+!
The total fill capacity for a 2003 Hyundai Tiburon is 8.2 quarts (including the fluid inside the torque converter). However for just a drain/fluid change, it will probably require about half that amount. If you still have the owner's manual, that would be a good place to look. The fluid capacities should be listed. If not, try calling the parts or service department of your local Hyundai dealer.
No. It secures the headlight assembly in place. The headlight adjustments are the square slot crews that have a spring assembly around them.
To take it off all you have to do is locate all of the screws there are maybe around 10 i snapped somthing off on mine when i did it so be carful there are hidden ones inside of the inside handel
With the hood open, remove the plastic cover the exposes the inside of the headlight. There are 3 clips to remove from the inside, plus the wire harness. The headlight just comes out from the out side then. You might have to replace some of the clips, only found at Ford, and about 7 bucks ea.
The total fill capacity for a 2003 Hyundai Tiburon is 8.2 quarts (including the fluid inside the torque converter). However for just a drain/fluid change, it will probably require about half that amount. If you still have the owner's manual, that would be a good place to look. The fluid capacities should be listed. If not, try calling the parts or service department of your local Hyundai dealer.
Open the hood and loosen the gray plastic wing nut on the inside top corner of the headlight.
The Plastic Gear Inside the Headlight is Worn, atleast half of it. You can buy a metal gear for $40 and replace the plastic gear.