It would be reasonable to assume that this filter will be the same as an in ground filter.Here is what you do These are the instructions for backwashing a sand filter
(1) stop the pool filter if it is going
(2) empty out the leaf basket and the Hair filter so that there is no obstruction before the pump.
(3)Turn the lever on the top of the sand filter from the filter position to the backwash position, usually in the opposite direction. You will note a clear bubble some where near the multi port control on the top of the sand filter, keep an eye on this once the backwash has started
(4) switch the pump on. You will note water rushing around in the clear bubble. at firs the water will be clean then it will turn dirty when it clears up again let it run for another minute or so then turn of the pump.
(5) now turn the lever on the top of the sand filter to rinse. once again you will notice the bubble get a title cloudy when it is clear let it run another 30 seconds and turn the pump of again.
(6) Now turn the lever on top of the sand filter back to its original position which should be filter. and its all done.
Some systems do not have the observation bubble. with these if you can see the backwash water go to waste keep an eye on it instead. or just wait til you loose about 100mm / 4" from the top of the pool.
there is a possibility of getting a little cloudy water coming back into the pool after this, don't worry about it it will soon settle down and it only indicates that the rinse wasn't quite long enough.
Try running a sand cleaner through the pump at the end of each season. Have the sand changed every 2-3 years.
The most important accessories for keeping a pool clean are a moving filter, a net for scooping out debris, and a ph testing system. These are the basics to maintain a healthy pool.
Filter it then swim in it.
Closed
NO!
The cleaning schedules varies from filter to filter, but a general guideline on any swimming pool filter is to take a reading when the filter is clean, then clean the pool filter when the pressure rises about 10 psi.
NO POWER CORDS IN THEW POOL ! I KNOW ITS HARD TO KEEP THESE CLEAN SO THE BEST WAY IS TO FIND A INGROUND PUMP AND FILTER SAY A 1 HP STA RITE DURA GLAS AND A 50 SQ FOOT CARTRIDGE TYPE FILTER. WHEN THE POOL GOES BAD YOU WILL BE ABLE TO RESELL THE PUMP AND FILTER AND GET YOUR MONEY BACK..
Need to rephrase question.
Usa a shop vac.
Justin Bieber has a inground pool
I have an inground spa when I turn on the jets they start then stop. I have put pressure in the line nothing clean the filter nothing. What can I do
The rainwater will be treated by the chlorine in the pool and you may have to adjust the chlorine levels. See the related link for more information.
No